VOLVO
ECM-P201600 - Intake Manifold Runner Position Sensor/Switch Circuit Low (Bank 1). General Failure Information. No sub type information
Układ
Sterownik silnika (ECM)
Modele Volvo, których dotyczy ten kod błędu
Dotyczy następujących modeli:
5 modeliS80 (2007–), V70 (2008–), XC60 (2009–), XC70 (2008–), XC90 (2003–)
Pokaż modele wg rocznika i silnika (6)
- Volvo S80 (2007–)2007–2009Tylko silnik: D5244T4, D5244T5
- Volvo V70 (2008–)2008–2009Tylko silnik: D5244T4, D5244T5
- Volvo XC60 (2009–)2009Wszystkie silniki oprócz: B6304T2
- Volvo XC70 (2008–)2008Wszystkie silniki oprócz: B6324S
- Volvo XC70 (2008–)2009Tylko silnik: D5244T4, D5244T5
- Volvo XC90 (2003–)2013–2014Tylko silnik: D5244T18, D5244T5
Co oznacza ten kod błędu?
The engine control module (ECM) checks the supply voltage to the swirl damper motor position sensor. The code is set when the signal is incorrect and is tested with the ignition on. The cause may be a short circuit in the supply or signal wire, or a damaged sensor.
Możliwe przyczyny
- Power supply short-circuited to battery voltage
- Signal wire short-circuited to voltage
- Open circuit in the earth lead
- Damaged sensor
- Power supply short-circuited to ground
- Short circuit to ground in the signal wire
Co możesz zrobić
- 1Check that the fuses are intact
- 2Check that the connector to the swirl damper position sensor is clean and secure
- 3Use a multimeter to check that the supply wire has no contact with ground and that the earth lead has no open circuit
- 4If you have a diagnostic tool: read the status of the code with the ignition on and see whether it is active
- 5If the fault remains, have a workshop check the position sensor and the wiring with diagnostic equipment
Objawy, które możesz zauważyć1
- No noticeable symptoms for the driver
Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.