VOLVO
ECM-P212100 - Throttle/Pedal Position Sensor/Switch D Circuit Range/Performance. General Failure Information. No sub type information
Układ
Sterownik silnika (ECM)
Modele Volvo, których dotyczy ten kod błędu
Dotyczy następujących modeli:
9 modeliC30 (2007–2013), S40 (2004–2013), S60 (2011–), S80 (2007–), V40 (2013–), V40 Cross Country (2013–), V50 (2004–2013), V60 (2011–), V70 (2008–)
Pokaż modele wg rocznika i silnika (13)
- Volvo C30 (2007–2013)2011–2013Tylko silnik: D4162T
- Volvo S40 (2004–2013)2011–2012Tylko silnik: D4162T
- Volvo S60 (2011–)2011–2015Tylko silnik: D4162T
- Volvo S80 (2007–)2008–2010Tylko silnik: B4204S3, B4204S4, D4204T
- Volvo S80 (2007–)2011Tylko silnik: B4204S3, B4204S4
- Volvo S80 (2007–)2012–2015Tylko silnik: D4162T
- Volvo V40 (2013–)2013–2015Tylko silnik: D4162T
- Volvo V40 Cross Country (2013–)2013–2015Tylko silnik: D4162T
- Volvo V50 (2004–2013)2011–2012Tylko silnik: D4162T
- Volvo V60 (2011–)2011–2015Tylko silnik: D4162T
- Volvo V70 (2008–)2008–2010Tylko silnik: B4204S3, B4204S4, D4204T
- Volvo V70 (2008–)2011Tylko silnik: B4204S3, B4204S4
- Volvo V70 (2008–)2012–2015Tylko silnik: D4162T
Co oznacza ten kod błędu?
The control module compares the readings from two accelerator pedal sensors. The code is set when the signal from the accelerator pedal sensor is missing, incorrect or too low. It can also be set wrongly after a module in the car has been reprogrammed.
Możliwe przyczyny
- Communication fault on the CAN bus
- Damaged accelerator pedal position sensor
- Poor contact, oxidation or a loose plug in the connector
- The signal wire is short-circuited to ground
Co możesz zrobić
- 1Start by checking the central electronic module (CEM) and the other control modules involved for stored codes, and fix those first
- 2Clear this code only after the codes in the other control modules have been fixed and cleared
- 3If a control module in the vehicle has recently been reprogrammed, the code may have been set incorrectly. In that case you can disregard it
- 4Check that the fuses are intact
- 5Check the connectors at the pedal sensor and the engine control module for contact resistance, looseness and oxidation
- 6If the fault remains, have a workshop with diagnostic equipment trace the CAN communication and the pedal sensor
Objawy, które możesz zauważyć3
- Poor response from the accelerator pedal
- A text message and a warning symbol appear in the display
- The engine lacks power and performs poorly
Na co może wpływać usterka1
- Engine torque may be limited
Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.