VOLVO
ECM-P212600 - Throttle/Pedal Position Sensor/Switch E Circuit Range/Performance. General Failure Information. No sub type information
Układ
Sterownik silnika (ECM)
Modele Volvo, których dotyczy ten kod błędu
Dotyczy następujących modeli:
2 modeleS80 (2007–), V70 (2008–)
Pokaż modele wg rocznika i silnika (2)
Co oznacza ten kod błędu?
The engine control module (ECM) has detected that the pulse length of the pulse width modulated (PWM) signal from accelerator pedal sensor circuit 2 is wrong. The fault therefore concerns the accelerator pedal signal. The code can also have been set in error after a control module in the car was reprogrammed, so check whether any module has recently been reprogrammed.
Możliwe przyczyny
- Damaged accelerator pedal sensor
- Code set in error after a control module in the car was reprogrammed
Co możesz zrobić
- 1Check whether any control module in the car has recently been reprogrammed, as that can cause this code to be set in error
- 2Check that the accelerator pedal connector and wiring are secure and not chafed or corroded
- 3With a diagnostic tool, check that the pedal value in live data follows slow presses and releases of the pedal
- 4Remedy as needed, then erase the code and road test the car to check that it does not come back
- 5Replace the accelerator pedal sensor only if the fault remains and the wiring is intact
Objawy, które możesz zauważyć1
- Poor response from the accelerator pedal
Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.