ECM-P217800
VOLVO
ECM-P217800 - System Too Rich Off Idle - Bank 1. General Failure Information. No sub type information
Układ
Sterownik silnika (ECM)
Modele Volvo, których dotyczy ten kod błędu
Dotyczy następujących modeli:
7 modeliS60 (2011–), S80 (2007–), V40 (2013–), V40 Cross Country (2013–), V60 (2011–), V70 (2008–), XC60 (2009–)
Pokaż modele wg rocznika i silnika (20)
- Volvo S60 (2011–)2011Tylko silnik: B4164T, B4164T3, B4204T6, B4204T7
- Volvo S60 (2011–)2012–2014Tylko silnik: B4164T, B4164T2, B4164T3, B4204T7
- Volvo S60 (2011–)2015Tylko silnik: B4164T, B4164T2, B4164T3
- Volvo S80 (2007–)2010Tylko silnik: B4204T6
- Volvo S80 (2007–)2011Tylko silnik: B4164T, B4204T6, B4204T7
- Volvo S80 (2007–)2012–2014Tylko silnik: B4164T, B4164T2, B4204T6, B4204T7
- Volvo S80 (2007–)2015Tylko silnik: B4164T
- Volvo V40 (2013–)2013Tylko silnik: B4164T, B4164T3
- Volvo V40 (2013–)2014–2015Tylko silnik: B4164T, B4164T3, B4164T4
- Volvo V40 Cross Country (2013–)2013–2015Tylko silnik: B4164T
- Volvo V60 (2011–)2011Tylko silnik: B4164T, B4164T3, B4204T6, B4204T7
- Volvo V60 (2011–)2012–2014Tylko silnik: B4164T, B4164T2, B4164T3, B4204T7
- Volvo V60 (2011–)2015Tylko silnik: B4164T, B4164T2, B4164T3
- Volvo V70 (2008–)2010Tylko silnik: B4204T6
- Volvo V70 (2008–)2011Tylko silnik: B4164T, B4204T6, B4204T7
- Volvo V70 (2008–)2012–2014Tylko silnik: B4164T, B4164T2, B4204T7
- Volvo V70 (2008–)2015Tylko silnik: B4164T, B4164T2
- Volvo XC60 (2009–)2010Tylko silnik: B4204T6
- Volvo XC60 (2009–)2011–2012Tylko silnik: B4204T6, B4204T7
- Volvo XC60 (2009–)2013–2015Tylko silnik: B4204T7
Co oznacza ten kod błędu?
The engine control module (ECM) adjusts injection from the lambda sensor reading to keep the mixture at λ=1. The code is set when that adjustment has to be made close to its maximum in the lower or upper part-load range. The fault may lie in a leak after the turbo, the mass air flow sensor, the fuel pressure, the lambda sensor, the injectors or the fuel itself.
Możliwe przyczyny
- Air leakage after the turbocharger, between the turbo and the throttle unit
- Damaged mass air flow (MAF) sensor
- Low fuel pressure
- Damaged heated oxygen sensor (HO2S)
- Damaged or incorrect type of injectors
- Incorrectly calculated ethanol content
Co możesz zrobić
- 1Check that the fuses are intact; their locations are in the owner's manual or on the fuse box cover
- 2Look for leaks between the mass air flow sensor and the turbocharger
- 3Have a workshop measure the fuel pressure and check that it is not too low
- 4Check the mass air flow sensor for damage and dirt, and check its connectors and wiring
- 5Think back on how the car has been refuelled; have a workshop check the ethanol calculation if needed
- 6Replace the lambda sensor if nothing above cures the fault, since a damaged lambda sensor can also set this code
Objawy, które możesz zauważyć1
- The malfunction indicator lamp lights up or behaves abnormally
Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.