VOLVO
ECM-P250A16 - Engine Oil Level Sensor Circuit. General Electrical Failures. Circuit voltage below threshold
Układ
Sterownik silnika (ECM)
Modele Volvo, których dotyczy ten kod błędu
Dotyczy następujących modeli:
5 modeliS80 (2007–), V70 (2008–), XC60 (2009–), XC70 (2008–), XC90 (2003–)
Pokaż modele wg rocznika i silnika (6)
- Volvo S80 (2007–)2007–2009Tylko silnik: D5244T4, D5244T5
- Volvo V70 (2008–)2008–2009Tylko silnik: D5244T4, D5244T5
- Volvo XC60 (2009–)2009Wszystkie silniki oprócz: B6304T2
- Volvo XC70 (2008–)2008Wszystkie silniki oprócz: B6324S
- Volvo XC70 (2008–)2009Tylko silnik: D5244T4, D5244T5
- Volvo XC90 (2003–)2013–2014Tylko silnik: D5244T18, D5244T5
Co oznacza ten kod błędu?
The engine control module (ECM) keeps track of the engine oil level and calculates an average value from it. The code is stored when that calculated average is incorrect. Possible causes are an oil level that is too low, poor contact or a damaged oil level sensor.
Możliwe przyczyny
- Oil level too low
- Contact resistance or oxidation in the terminals (see also ECM-P250A1C)
- Damaged oil level sensor
Co możesz zrobić
- 1Check the oil level with the dipstick and top up with the correct oil if it is low
- 2Check that the relevant fuses are intact
- 3Check the connector to the oil level sensor for contact resistance and oxidation; clean and remedy it if needed
- 4If you have a diagnostic tool, read the fault status with the ignition on and see whether the fault is still active
- 5If the fault remains after these checks, have a workshop with diagnostic equipment check the oil level sensor
Objawy, które możesz zauważyć1
- No noticeable symptoms for the driver
Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.