VOLVO
ECM-P251900 - A/C Request A Circuit. General Failure Information. No sub type information
Układ
Sterownik silnika (ECM)
Modele Volvo, których dotyczy ten kod błędu
Dotyczy następujących modeli:
3 modeleS60 (2011–), S80 (2007–), V70 (2008–)
Pokaż modele wg rocznika i silnika (9)
- Volvo S60 (2011–)2011–2012Tylko silnik: B5254T5
- Volvo S80 (2007–)2007–2008Tylko silnik: B5254T6
- Volvo S80 (2007–)2009Tylko silnik: B5254T6, B5254T8
- Volvo S80 (2007–)2010–2011Tylko silnik: B5254T10, B5254T11, B5254T8
- Volvo S80 (2007–)2012Tylko silnik: B5254T10
- Volvo V70 (2008–)2008Tylko silnik: B5254T6
- Volvo V70 (2008–)2009Tylko silnik: B5254T6, B5254T8
- Volvo V70 (2008–)2010–2011Tylko silnik: B5254T10, B5254T11
- Volvo V70 (2008–)2012Tylko silnik: B5254T10
Co oznacza ten kod błędu?
The engine control module sets the stroke volume of the A/C compressor through a control valve (solenoid) driven by a PWM signal. The code is checked when A/C is switched on, and it is stored when the signal from the control valve is outside the limits the control module uses. This may be due to a short in the signal wire, an open circuit in the supply wire or a damaged control valve.
Możliwe przyczyny
- Signal cable shorted to supply voltage
- Signal cable short-circuited to ground
- Open circuit in the voltage supply cable
- Damaged control valve (solenoid)
Co możesz zrobić
- 1If you have a diagnostic tool, activate the A/C compressor and read the control valve drive signal in live data
- 2Check that the relevant fuses are intact
- 3Check the connector to the control valve in the A/C compressor for contact resistance and oxidation
- 4Use a multimeter to check that the signal wire to the control valve has no open circuit and is not short-circuited to plus or to ground (body)
- 5If the fault remains, have a workshop with diagnostic equipment check the control valve in the A/C compressor
Objawy, które możesz zauważyć1
- Uneven cooling from the A/C system
Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.