VOLVO
ECM-P252A17 - Engine Oil Quality Sensor Circuit. General Electrical Failures. Circuit voltage above threshold
Układ
Sterownik silnika (ECM)
Modele Volvo, których dotyczy ten kod błędu
Dotyczy następujących modeli:
5 modeliS80 (2007–), V70 (2008–), XC60 (2009–), XC70 (2008–), XC90 (2003–)
Pokaż modele wg rocznika i silnika (6)
- Volvo S80 (2007–)2007–2009Tylko silnik: D5244T4, D5244T5
- Volvo V70 (2008–)2008–2009Tylko silnik: D5244T4, D5244T5
- Volvo XC60 (2009–)2009Wszystkie silniki oprócz: B6304T2
- Volvo XC70 (2008–)2008Wszystkie silniki oprócz: B6324S
- Volvo XC70 (2008–)2009Tylko silnik: D5244T4, D5244T5
- Volvo XC90 (2003–)2013–2014Tylko silnik: D5244T18, D5244T5
Co oznacza ten kod błędu?
The code concerns an incorrect PWM signal from the combined sensor for oil quality, level and temperature. The cause may be a supply or signal wire with an open circuit or a short to voltage, but a damaged sensor or a poor connection can also be behind it.
Możliwe przyczyny
- Supply open or shorted to voltage, or the signal wire is open or shorted to voltage
- Contact resistance or oxidation in the connections (see ECM-P252A1C)
- Damaged oil level sensor
- Voltage supply short-circuited to ground (see ECM-P252A16)
- Signal wire short-circuited to ground (see ECM-P252A16)
- Intermittent open circuit in the signal wire (see ECM-P252A1C)
Co możesz zrobić
- 1Read the fault status with the ignition on and see whether the fault is still active
- 2Check that the relevant fuses are intact
- 3Use a multimeter to check that the supply and signal wires to the combined sensor are not short-circuited to plus
- 4Check the connector to the combined sensor and make sure it is secure and clean
- 5If the fault remains after these checks, have a workshop with diagnostic equipment check the combined sensor
Objawy, które możesz zauważyć1
- No noticeable symptoms for the driver
Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.