VOLVO
ECM-P263400 - Fuel Pump "B" Control Circuit High. General Failure Information. No sub type information
Układ
Sterownik silnika (ECM)
Modele Volvo, których dotyczy ten kod błędu
Dotyczy następujących modeli:
8 modeliS60 (2011–), S80 (2007–), V40 (2013–), V40 Cross Country (2013–), V60 (2011–), V70 (2008–), XC60 (2009–), XC70 (2008–)
Pokaż modele wg rocznika i silnika (8)
- Volvo S60 (2011–)2014–2015Tylko silnik: B4204T10, B4204T11, B4204T12, B4204T15, B4204T9
- Volvo S80 (2007–)2014–2015Tylko silnik: B4204T11, B4204T12, B4204T15
- Volvo V40 (2013–)2015Tylko silnik: B4204T11
- Volvo V40 Cross Country (2013–)2015Tylko silnik: B4204T11
- Volvo V60 (2011–)2014–2015Tylko silnik: B4204T11, B4204T12, B4204T15, B4204T9
- Volvo V70 (2008–)2014–2015Tylko silnik: B4204T11
- Volvo XC60 (2009–)2014–2015Tylko silnik: B4204T10, B4204T11, B4204T12, B4204T15, B4204T9
- Volvo XC70 (2008–)2014–2015Tylko silnik: B4204T11
Co oznacza ten kod błędu?
Fuel pump B has a control signal from the engine control module (ECM) to the fuel pump control module (PEM). The code is set when the ECM finds a fault in that signal. The cause can be a signal wire shorted to supply voltage, a damaged control module or a fault registered by the CEM.
Możliwe przyczyny
- A fault logged by the CEM
- Signal wire shorted to supply voltage
- Damaged fuel pump control module
Co możesz zrobić
- 1Deal first with any codes stored in the CEM
- 2Use a multimeter to check that the control signal wire has no contact with the positive supply
- 3Check the wire from the CEM to the fuel pump control module for chafing and pinching that could let it touch the supply voltage
- 4If you have a diagnostic tool, activate the fuel pump and check that it starts
- 5If nothing is found, have a workshop check the fuel pump control module
Objawy, które możesz zauważyć2
- Engine cranks but does not start
- Engine may stall while driving, at any time
Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.