VOLVO
ECM-P26DC00 - Engine Sound Control "A" Circuit Low. General Failure Information. No sub type information
Układ
Sterownik silnika (ECM)
Modele Volvo, których dotyczy ten kod błędu
Dotyczy następujących modeli:
6 modeliS60 (2011–), S80 (2007–), V60 (2011–), V70 (2008–), XC60 (2009–), XC70 (2008–)
Pokaż modele wg rocznika i silnika (8)
- Volvo S60 (2011–)2011–2014Tylko silnik: B6304T4
- Volvo S60 (2011–)2015Tylko silnik: B6304T4, B6304T5
- Volvo S80 (2007–)2011–2015Tylko silnik: B6304T4
- Volvo V60 (2011–)2011–2014Tylko silnik: B6304T4
- Volvo V60 (2011–)2015Tylko silnik: B6304T4, B6304T5
- Volvo V70 (2008–)2011–2015Tylko silnik: B6304T4
- Volvo XC60 (2009–)2011–2015Tylko silnik: B6304T4
- Volvo XC70 (2008–)2011–2015Tylko silnik: B6304T4
Co oznacza ten kod błędu?
The engine control module (ECM) drives exhaust damper A with a pulse width modulated signal and checks that the signal is correct. The code is set when the signal to the damper is too low, and the cause may lie in the connections, the wiring or the damper itself.
Możliwe przyczyny
- Contact resistance and oxidation in the connections
- The signal wire is shorted to ground
- The exhaust damper is damaged
- Exhaust damper A is on the right-hand side as seen in the direction of travel
Co możesz zrobić
- 1Check that the fuses are intact; their location is shown in the owner's manual
- 2Check the connector to damper A for contact resistance, oxidation and looseness
- 3Use a multimeter to check that the signal wire to damper A has no contact with ground (the body)
- 4With a diagnostic tool, activate damper A and check in live data whether the damper value changes when it is controlled
- 5Have a workshop check damper A if the fault remains after the connector and wiring checks
Objawy, które możesz zauważyć3
- Unusual noise while driving, sometimes or all the time
- Unusual noise when the engine is switched off
- Unusual noise during acceleration
Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.