VOLVO
ECM-P26DD00 - Engine Sound Control "A" Circuit High. General Failure Information. No sub type information
Układ
Sterownik silnika (ECM)
Modele Volvo, których dotyczy ten kod błędu
Dotyczy następujących modeli:
6 modeliS60 (2011–), S80 (2007–), V60 (2011–), V70 (2008–), XC60 (2009–), XC70 (2008–)
Pokaż modele wg rocznika i silnika (8)
- Volvo S60 (2011–)2011–2014Tylko silnik: B6304T4
- Volvo S60 (2011–)2015Tylko silnik: B6304T4, B6304T5
- Volvo S80 (2007–)2011–2015Tylko silnik: B6304T4
- Volvo V60 (2011–)2011–2014Tylko silnik: B6304T4
- Volvo V60 (2011–)2015Tylko silnik: B6304T4, B6304T5
- Volvo V70 (2008–)2011–2015Tylko silnik: B6304T4
- Volvo XC60 (2009–)2011–2015Tylko silnik: B6304T4
- Volvo XC70 (2008–)2011–2015Tylko silnik: B6304T4
Co oznacza ten kod błędu?
The code concerns the signal to exhaust damper A, which the engine control module (ECM) drives with a pulse width modulated signal. It is set when the signal is too high, and the cause may be poor contact, a signal wire that has touched voltage, or a damaged damper.
Możliwe przyczyny
- Contact resistance and oxidation in the connections
- The signal wire is shorted to voltage
- The exhaust damper is damaged
- Exhaust damper A is on the right-hand side as seen in the direction of travel
Co możesz zrobić
- 1Check that the fuses are intact; their location is shown in the owner's manual
- 2Check that the connector to damper A is clean and secure, with no oxidation or looseness
- 3Use a multimeter to check that the signal wire to damper A has no contact with positive supply
- 4With a diagnostic tool you can activate damper A and see in live data whether the damper value follows the control
- 5Have a workshop check damper A if the fault remains after the connector and wiring checks
Objawy, które możesz zauważyć3
- Unusual noise while driving, sometimes or all the time
- Unusual noise when the engine is switched off
- Unusual noise during acceleration
Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.