VOLVO
ECM-U010387 - Lost Communication With Gear Shift Control Module A. Bus Signal / Message Failures. Missing message
Układ
Sterownik silnika (ECM)
Modele Volvo, których dotyczy ten kod błędu
Dotyczy następujących modeli:
8 modeliS60 (2011–), S80 (2007–), V40 (2013–), V40 Cross Country (2013–), V60 (2011–), V70 (2008–), XC60 (2009–), XC70 (2008–)
Pokaż modele wg rocznika i silnika (8)
- Volvo S60 (2011–)2014–2015Tylko silnik: B4204T10, B4204T11, B4204T12, B4204T15, B4204T9, D4204T5
- Volvo S80 (2007–)2014–2015Tylko silnik: B4204T11, B4204T12, B4204T15, D4204T5
- Volvo V40 (2013–)2015Tylko silnik: B4204T11, D4204T14
- Volvo V40 Cross Country (2013–)2015Tylko silnik: B4204T11, D4204T14
- Volvo V60 (2011–)2014–2015Tylko silnik: B4204T11, B4204T12, B4204T15, B4204T9, D4204T5
- Volvo V70 (2008–)2014–2015Tylko silnik: B4204T11, D4204T5
- Volvo XC60 (2009–)2014–2015Tylko silnik: B4204T10, B4204T11, B4204T12, B4204T15, B4204T9, D4204T5
- Volvo XC70 (2008–)2014–2015Tylko silnik: B4204T11, D4204T5
Co oznacza ten kod błędu?
The ECM watches TCM signals and also waits for the gear selector (GSM) signal. The code is set when the signal from the gear selector is missing, and the cause may be an open circuit or a short circuit in the signal wire.
Możliwe przyczyny
- Open circuit or short circuit in the signal wire
Co możesz zrobić
- 1Read the code with a diagnostic tool and see whether it is active or only stored
- 2Check that the connectors on the signal wire to the gear selector are secure and free from oxidation
- 3Use a multimeter to check that the signal wire to the gear selector has no break or short to ground or voltage
- 4Have a workshop check the gear selector and the signal wire if the fault remains
Objawy, które możesz zauważyć1
- No noticeable symptoms for the driver
Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.