VOLVO
IEM-U002888 - Vehicle Communication Bus A. Bus Signal / Message Failures. Bus off
Układ
Nieznany układ / Specyficzny dla marki
Modele Volvo, których dotyczy ten kod błędu
Dotyczy następujących modeli:
1 modelV60 (2011–)
Pokaż modele wg rocznika i silnika (2)
Co oznacza ten kod błędu?
The electric rear axle drive module (IEM) sends or receives faulty messages on the sensor CAN, or has lost contact with the sensor CAN. The module then shuts down its communication on the bus. The fault is only checked once the test has started at ignition on, and the code is stored when the conditions are met.
Możliwe przyczyny
- Break in one or both CAN wires somewhere in the network
- Software error in the electric rear axle drive module (IEM)
- Internal fault inside the ISC voltage converter
Co możesz zrobić
- 1Read out and note the code, clear it, then start the car and see whether it returns
- 2Have a workshop check that the connectors to the control modules linked to the sensor CAN are fully engaged and free from corrosion
- 3Have a workshop check chafed or damaged CAN cables
- 4Have a workshop with diagnostic equipment check the CAN network and identify which control module is communicating incorrectly, since the fault can lie in the cables or in a control module
- 5Do not work on the electric rear axle or its high voltage system yourself; have a workshop carry out those checks
Objawy, które możesz zauważyć4
- Warning symbol and text message in the display
- PURE drive mode disengages by itself or is not available
- AWD drive mode disengages by itself or is not available
- HYBRID drive mode runs with the combustion engine active all the time or too often
Na co może wpływać usterka3
- The control module switches itself off on the sensor CAN (bus-off) and stays off until the power supply has been disconnected
- Electric propulsion is not possible
- Brake energy recovery from the electric rear axle ERAD is not possible
Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.