VOLVO
IGM-U000188 - High Speed CAN Communication Bus. Bus Signal / Message Failures. Bus off
Układ
Nieznany układ / Specyficzny dla marki
Modele Volvo, których dotyczy ten kod błędu
Dotyczy następujących modeli:
1 modelV60 (2011–)
Pokaż modele wg rocznika i silnika (2)
Co oznacza ten kod błędu?
The high voltage generator control module (IGM) communicates with the other control modules over HS CAN. The code is stored when incorrect messages are sent or received on HS CAN, or when contact with HS CAN is lost. The fault is only checked once the test has started at ignition on.
Możliwe przyczyny
- Open circuit in one or both CAN wires in part of the network
- Software fault in the IGM
- Internal fault inside the ISC voltage converter
Co możesz zrobić
- 1Read out, clear the code and start the car to see whether it returns
- 2Have a workshop check chafed or pinched CAN wires and check that the connectors on HS CAN are fully engaged
- 3Have a workshop with diagnostic equipment measure on the CAN network and establish whether the fault lies in the wiring or in a control module
- 4The high voltage system may only be handled by a workshop; do not work on it yourself
Objawy, które możesz zauważyć5
- Warning symbol and text message in the display
- Warning about power supply problems from the alternator and charge regulator
- Charging of the high voltage battery while driving is absent, reduced or not working correctly
- High voltage battery is discharged or charges poorly
- HYBRID drive mode: the combustion engine is active all the time or too often
Na co może wpływać usterka3
- The control module switches itself off (bus-off) and stays off until the power supply has been disconnected
- The high voltage battery cannot be charged by the combustion engine
- When the power supply is reconnected, the control module tries to communicate again
Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.