VOLVO
KVM-U210000 - Control Module Not Configured. General Failure Information. No sub type information
Układ
Moduł dostępu bezkluczykowego (KVM)
Modele Volvo, których dotyczy ten kod błędu
Dotyczy następujących modeli:
9 modeliS60 (2011–), S80 (2007–), V40 (2013–), V40 Cross Country (2013–), V60 (2011–), V60 Cross Country (2015–), V70 (2008–), XC60 (2009–), XC70 (2008–)
Co oznacza ten kod błędu?
The keyless vehicle module (KVM) reads the car's settings from the CEM during the first ignition cycle. If that data does not arrive, the code is set and the module is not configured for the car. The fault may lie in the CAN wiring or in either of the two modules.
Możliwe przyczyny
- Open circuit or short circuit in the CAN wiring
- Internal fault in the keyless vehicle module (KVM)
- Internal fault in the CEM module
Co możesz zrobić
- 1Check that the fuses for the keyless system are intact
- 2Look at the battery and make sure its terminals are clean and tight
- 3Road test the car and try the functions the keyless system controls, such as locking and unlocking with the remote, to see what still works
- 4If you have diagnostic equipment, read the codes in the central electronic module (CEM), since they can show communication faults on the CAN network
- 5Have a workshop check the CAN wiring and, if needed, test or replace the control modules that are suspected
Objawy, które możesz zauważyć1
- No, or reduced, keyless function
Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.