VOLVO
LPG-0108 - Manifold absolute pressure (MAP) sensor. Signal too high
Układ
Instalacja gazowa (LPG)
Modele Volvo, których dotyczy ten kod błędu
Dotyczy następujących modeli:
2 modeleS40 (1996–2004), V40 (1996–2004)
Pokaż modele wg rocznika i silnika (2)
Co oznacza ten kod błędu?
The LPG control module monitors the signal from the pressure sensor in the intake manifold and sets the code when that signal is too high while the engine is running.
Możliwe przyczyny
- Contact resistance or oxidation in the connector on the LPG control module
- Contact resistance or oxidation in the connector on the pressure sensor
- Open circuit or short circuit to supply voltage in the ground wire
- Short circuit to supply voltage in the signal wire
- Defective manifold pressure sensor in the intake manifold
Co możesz zrobić
- 1Start the engine and read the intake manifold pressure with diagnostic equipment; if the pressure looks normal, the fault has probably been present but is not active at the moment
- 2Check the connectors on the LPG control module and the pressure sensor for poor contact and oxidation
- 3Check the signal wire for chafing and damage, and use a multimeter to confirm it has no contact with supply voltage
- 4Check the ground wire to the pressure sensor for breaks, and use a multimeter to confirm it has no contact with supply voltage
- 5Have a workshop try replacing the pressure sensor in the intake manifold if no fault is found
Objawy, które możesz zauważyć1
- Poor performance
Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.