VOLVO
PBM-U210054 - Control Module Not Configured. System Programming Failures. Missing calibration
Układ
Układ napędowy (Silnik i skrzynia biegów)
Modele Volvo, których dotyczy ten kod błędu
Dotyczy następujących modeli:
9 modeliS60 (2011–), S80 (2007–), V40 (2013–), V40 Cross Country (2013–), V60 (2011–), V60 Cross Country (2015–), V70 (2008–), XC60 (2009–), XC70 (2008–)
Co oznacza ten kod błędu?
The electronic parking brake module (PBM) has a built-in inclination sensor used to decide how hard to apply the brake on a slope. The code means the inclination sensor has not been calibrated, the installation check has not been done, or the module is still in service mode.
Możliwe przyczyny
- The inclination sensor has not been calibrated, for example after replacing the module
- The installation check has not been carried out after fitting
- Service mode is still active, for example after replacing the rear brake pads
Co możesz zrobić
- 1Find out whether the rear brakes or the parking brake module have recently been serviced or replaced
- 2Have a workshop with diagnostic equipment exit service mode, calibrate the inclination sensor and run the installation check
- 3Afterwards, check that the parking brake applies and releases correctly
- 4Do not rely on the parking brake on a slope until the fault is fixed – leave the car in gear or in P
Objawy, które możesz zauważyć3
- Parking brake warning lamp on
- Yellow warning symbol and message in the display
- The parking brake has reduced function
Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.