VOLVO
REM-6A11 - Door switch. Signal too high
Układ
Tylny moduł elektroniczny (REM)
Modele Volvo, których dotyczy ten kod błędu
Dotyczy następujących modeli:
5 modeliS60 (2001–2009), S80 (1999–2006), V70 (2000–2008), V70 XC / XC70 (2001–2007), XC90 (2003–)
Co oznacza ten kod błędu?
The REM registers too high a signal from a door switch, which normally shows that the door is closed. The cause is that the switch is shorted to supply voltage. The module reads the switches with short voltage pulses, and the fault can give a wrong door alarm and a warning lamp on the instrument panel.
Możliwe przyczyny
- The switch indicating a closed door is shorted to supply voltage
Co możesz zrobić
- 1With the ignition on, read the door status and open and close the doors one at a time. The status for each door should change when it is opened and closed
- 2If the status does not change, the fault is permanent and the circuit for the door showing the fault should be checked
- 3Check the connector and wiring at the door for chafing, loose connectors and damage
- 4Use a multimeter to check that the wire to the switch has no contact with the positive supply
- 5If the fault remains, have a workshop with diagnostic equipment check the switch and the control module
Objawy, które możesz zauważyć3
- General warning lamp on
- Message shown in the text display
- The door alarm does not trigger
Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.