VOLVO
REM-6A13 - Door switch. Signal too high
Układ
Tylny moduł elektroniczny (REM)
Modele Volvo, których dotyczy ten kod błędu
Dotyczy następujących modeli:
5 modeliS60 (2001–2009), S80 (1999–2006), V70 (2000–2008), V70 XC / XC70 (2001–2007), XC90 (2003–)
Co oznacza ten kod błędu?
A door switch in the rear doors gives the rear electronic module (REM) a signal that is too high, even though the switch should show that the door is closed. The fault is caused by the switch being shorted to supply voltage. Because the module reads the switches with brief voltage pulses, the fault can cause a lit general warning lamp and a message in the display.
Możliwe przyczyny
- The switch indicating a closed door is shorted to supply voltage
Co możesz zrobić
- 1With the ignition on, read the switch status and open and close the rear doors one at a time. The status for each door should change when it is opened and closed
- 2If the status does not change, the fault is permanent, and only the circuit for the door showing the fault needs checking
- 3Check the wiring and connector at the rear door for chafing, pinching and loose contacts
- 4Use a multimeter to check that the wire to the switch has no contact with voltage
- 5If the fault remains, have a workshop with diagnostic equipment check the switch and the control module
Objawy, które możesz zauważyć3
- General warning lamp on
- Message shown in the text display
- The door alarm does not react for the rear door
Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.