VOLVO
SAS-0013 - Steering wheel position signal R2. Signal too high. Intermittent fault
Układ
Czujnik kąta skrętu kierownicy (SAS)
Modele Volvo, których dotyczy ten kod błędu
Dotyczy następujących modeli:
5 modeliS60 (2001–2009), S80 (1999–2006), V70 (2000–2008), V70 XC / XC70 (2001–2007), XC90 (2003–)
Co oznacza ten kod błędu?
Steering wheel position signal R2 reads too high. The fault is intermittent and may have occurred earlier without being active now. Possible causes are poor contact, a short to supply voltage, an open circuit in the wiring, or a defective control module.
Możliwe przyczyny
- Contact resistance or oxidation in connections and connectors
- Short circuit to voltage supply
- Open circuit in the wiring
- Defective control module
Co możesz zrobić
- 1Read and note the code, clear it and road test to see whether it returns
- 2Check that the connector at the steering wheel angle sensor is firmly seated, clean and free from corrosion
- 3Inspect the wiring between the sensor and the control module for chafing and loose clips, especially where the cable moves
- 4With diagnostic equipment, follow the R2 signal in live data while turning the wheel slowly and check that the value follows the wheel smoothly
- 5Stability control is off while the fault is present, so have a workshop repair it promptly if it returns
Objawy, które możesz zauważyć3
- Anti-spin warning lamp on
- Stabilising function absent
- Anti-spin not working
Na co może wpływać usterka2
- Stability function disconnected
- Anti-spin function blocked
Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.