VOLVO
SAS-0025 - LED group 2 circuit. Signal too low
Układ
Czujnik kąta skrętu kierownicy (SAS)
Modele Volvo, których dotyczy ten kod błędu
Dotyczy następujących modeli:
5 modeliS60 (2001–2009), S80 (1999–2006), V70 (2000–2008), V70 XC / XC70 (2001–2007), XC90 (2003–)
Co oznacza ten kod błędu?
The current through LED group 2 in the sensor is too low. Possible causes are poor contact, a short to ground in the LED circuit, defective LEDs in the group, or a defective control module.
Możliwe przyczyny
- Contact resistance or oxidation in connections and connectors
- Short circuit to ground in the LED circuit
- LED 5-8 defective in the sensor
- Defective control module
Co możesz zrobić
- 1Read and note the code, clear it and road test to see whether it returns
- 2Check the connectors at the sensor control module and the steering wheel module for oxide and contact resistance
- 3With diagnostic equipment, if the current reads normal once the connectors are clean and firmly seated, poor contact or oxide was the cause
- 4Look for a short to ground in the sensor wiring; if no fault is found there, a workshop may need to replace the sensor
- 5Stability control is off while the fault is present, so have a workshop repair it promptly
Objawy, które możesz zauważyć3
- Anti-spin warning lamp is on
- Stabilising function absent
- Anti-spin does not work
Na co może wpływać usterka2
- AYC function blocked
- Anti-spin function blocked
Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.