VOLVO
SAS-E003 - Configuration fault Faulty configuration
Układ
Czujnik kąta skrętu kierownicy (SAS)
Modele Volvo, których dotyczy ten kod błędu
Ten kod błędu ma różne znaczenie w zależności od modelu, rocznika lub silnika. Wybierz znaczenie, które dotyczy Twojego samochodu.
Dotyczy następujących modeli:
5 modeliS60 (2001–2009), S80 (1999–2006), V70 (2000–2008), V70 XC / XC70 (2001–2007), XC90 (2003–)
Co oznacza ten kod błędu?
The steering angle sensor checks its configuration ID against the signal setup that the central electronic module (CEM) transmits over CAN. The code is set when the two disagree, or when the link to the CEM is cut. Ordinary CAN traffic then stops, although the sensor still answers diagnostic requests.
Możliwe przyczyny
- Wrong CAN configuration ID because the unit is meant for another vehicle, such as a used unit with different software or hardware.
- Open circuit in the CAN cabling linking the unit to the central electronic module (CEM).
Co możesz zrobić
- 1Check that the steering wheel module or angle sensor is intended for your car. A used part from another car can cause this code.
- 2Check that the connectors are firmly seated and not corroded, and have a workshop measure the wiring.
- 3If no other fault is found, a workshop can load new software into the angle sensor, but only after agreeing it with you.
- 4The angle sensor is part of the stability system. Have a workshop carry out the fault tracing and any software loading rather than working on the steering wheel yourself.
Objawy, które możesz zauważyć4
- The anti-spin warning lamp lights up on cars of model year 2002 and earlier
- The general warning lamp lights up on cars of model year 2003 and later
- The stability function does not work
- A message appears in the text display
Na co może wpływać usterka1
- The sensor cannot communicate normally on the CAN network
Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.