VOLVO
SAS-U210100 - Control Module Configuration Incompatible. General Failure Information. No sub type information
Układ
Czujnik kąta skrętu kierownicy (SAS)
Modele Volvo, których dotyczy ten kod błędu
Dotyczy następujących modeli:
4 modeleC30 (2007–2013), C70 (2006–2013), S40 (2004–2013), V50 (2004–2013)
Pokaż modele wg rocznika i silnika (8)
- Volvo C30 (2007–2013)2011Tylko silnik: D4162T, D4164T, D5204T, D5204T5
- Volvo C30 (2007–2013)2012–2013Tylko silnik: D4162T, D5204T, D5204T5
- Volvo C70 (2006–2013)2011Tylko silnik: D5204T, D5204T5
- Volvo C70 (2006–2013)2012–2013Wszystkie silniki oprócz: B5254T7
- Volvo S40 (2004–2013)2011Tylko silnik: D4162T, D4164T, D5204T, D5204T5
- Volvo S40 (2004–2013)2012Tylko silnik: D4162T, D5204T, D5204T5
- Volvo V50 (2004–2013)2011Tylko silnik: D4162T, D4164T, D5204T, D5204T5
- Volvo V50 (2004–2013)2012Tylko silnik: D4162T, D5204T, D5204T5
Co oznacza ten kod błędu?
This code means the steering angle sensor's configuration does not suit the car. It checks its configuration ID against the signal setup that the central electronic module (CEM) sends on the CAN network, and the code is set when the IDs disagree. The sensor then answers diagnostic commands, but ordinary CAN communication does not work.
Możliwe przyczyny
- Wrong configuration ID because the unit is not intended for this car, for example a used unit with different software or hardware.
- Incorrect software version.
Co możesz zrobić
- 1If the angle sensor is used or taken from another car, it is probably not intended for yours.
- 2Check that the fuses are intact. Their location is shown in the owner's manual or on the fuse box cover.
- 3Have a workshop read the fault codes, check the configuration and load new software if needed.
- 4The angle sensor is part of the steering and stability system. Have a workshop carry out the check rather than working on the steering wheel yourself.
Objawy, które możesz zauważyć4
- A yellow warning symbol and text message show in the display
- The anti-spin and anti-skid warning lamp lights up or behaves abnormally
- The anti-spin function does not work
- The stability function does not work
Na co może wpływać usterka1
- The sensor cannot communicate normally on the CAN network
Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.