VOLVO
SAS-U300362 - Battery Voltage. Algorithm Based Failures. Signal compare failure
Układ
Czujnik kąta skrętu kierownicy (SAS)
Modele Volvo, których dotyczy ten kod błędu
Dotyczy następujących modeli:
14 modeliC30 (2007–2013), C70 (2006–2013), S40 (2004–2013), S60 (2011–), S80 (2007–), V40 (2013–), V40 Cross Country (2013–), V50 (2004–2013), V60 (2011–), V60 Cross Country (2015–), V70 (2008–), XC60 (2009–), XC70 (2008–), XC90 (2003–)
Pokaż modele wg rocznika i silnika (19)
- Volvo C30 (2007–2013)2011–2013Tylko silnik: D4162T, D5204T, D5204T5
- Volvo C70 (2006–2013)2011Tylko silnik: D5204T, D5204T5
- Volvo C70 (2006–2013)2012–2013Wszystkie silniki oprócz: B5254T7
- Volvo S40 (2004–2013)2011–2012Tylko silnik: D4162T, D5204T, D5204T5
- Volvo S60 (2011–)2011–2015
- Volvo S80 (2007–)2007–2015
- Volvo V40 (2013–)2013–2015
- Volvo V40 Cross Country (2013–)2013–2015
- Volvo V50 (2004–2013)2011–2012Tylko silnik: D4162T, D5204T, D5204T5
- Volvo V60 (2011–)2011–2015
- Volvo V60 Cross Country (2015–)2015
- Volvo V70 (2008–)2008–2015
- Volvo XC60 (2009–)2009–2015
- Volvo XC70 (2008–)2008–2015
- Volvo XC90 (2003–)2005–2006Tylko silnik: B8444S
- Volvo XC90 (2003–)2007–2010Tylko silnik: B6324S, B8444S
- Volvo XC90 (2003–)2011Tylko silnik: B6324S5, B8444S
- Volvo XC90 (2003–)2012Tylko silnik: B6324S5
- Volvo XC90 (2003–)2013–2014Wszystkie silniki oprócz: B5254T9
Co oznacza ten kod błędu?
Although the code is named battery voltage, it applies when the steering angle sensor compares its voltage with that of the central electronic module (CEM) and the two do not agree. The cause can be poor contact or oxidation at the connector on the steering wheel module, or an internal fault in the sensor.
Możliwe przyczyny
- Poor contact or oxidised connector on the steering wheel module (SWM).
- Internal malfunction within the sensor (SAS).
Co możesz zrobić
- 1Clear the code and test drive the car. It mainly needs action if it has been active a long time and a function is lost.
- 2With a diagnostic tool and the ignition on, compare the voltage values of the steering angle sensor and the CEM. They should be roughly the same.
- 3Check that the fuses are intact and that the connectors to the steering wheel module are firmly seated and not corroded.
- 4Have a workshop replace the contact reel or angle sensor if the fault returns. If the code comes back after that, the steering wheel module (SWM) must be replaced.
- 5The angle sensor is part of the steering and stability system. Have a workshop carry out the checks and repair rather than working on the steering wheel yourself.
Objawy, które możesz zauważyć5
- The information lamp lights up
- The anti-spin warning lamp lights up
- Traction control and the stability function do not work
- The Four-C function does not work
- A yellow warning symbol and text message show in the display
Na co może wpływać usterka2
- The stability function is blocked
- The sensor warns the other control modules that the data it sends is wrong
Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.