VOLVO
SRS-C006A28 - Multi-axis Acceleration Sensor. General Signal Failures. Signal bias level out of range / zero adjustment failure
Układ
Układ poduszek powietrznych (SRS)
Modele Volvo, których dotyczy ten kod błędu
Dotyczy następujących modeli:
2 modeleV40 (2013–), V40 Cross Country (2013–)
Pokaż modele wg rocznika i silnika (2)
Co oznacza ten kod błędu?
The calibration of the inertial measurement unit (IMU) in the supplemental restraint system (SRS) could not be completed in full. The fault stays set until the calibration has been redone and has succeeded.
Możliwe przyczyny
- The IMU calibration did not succeed
Co możesz zrobić
- 1Have a workshop recalibrate the inertial measurement unit (IMU) with the car standing still on level ground and not rocking during the process
- 2A successful calibration shows as the text message clearing and the SRS warning light going out a short while after the ignition is switched back on
- 3After calibration, codes SRS-C006A28 and SRS-C006A54 must not be set; if either is still present, the calibration has failed and must be redone
- 4Have the workshop also calibrate the brake control module (BCM), since it needs the sensor signals to work without faults
- 5Do not work on the airbag system yourself; have a workshop check it if the calibration does not succeed
Objawy, które możesz zauważyć2
- Text message in the instrument cluster
- The SRS warning light comes on or behaves abnormally
Na co może wpływać usterka2
- Other systems that use the accelerometer signals do not work fully until calibration is complete
- The SRS functions still work without calibration
Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.