TCM-0492
VOLVO
TCM-0492 - Oil temperature sensor. Signal outside its permitted range
Układ
Sterownik automatycznej skrzyni biegów (TCM)
Modele Volvo, których dotyczy ten kod błędu
Dotyczy następujących modeli:
4 modeleC30 (2007–2013), C70 (2006–2013), S40 (2004–2013), V50 (2004–2013)
Pokaż modele wg rocznika i silnika (10)
- Volvo C30 (2007–2013)2008Tylko silnik: D4204T · Tylko skrzynia biegów: MPS6
- Volvo C30 (2007–2013)2009–2010Tylko silnik: B4204S3, D4204T · Tylko skrzynia biegów: MPS6
- Volvo C30 (2007–2013)2011–2013Tylko silnik: B4204S3 · Tylko skrzynia biegów: MPS6
- Volvo C70 (2006–2013)2009–2010Tylko silnik: D4204T · Tylko skrzynia biegów: MPS6
- Volvo S40 (2004–2013)2008Tylko silnik: D4204T · Tylko skrzynia biegów: MPS6
- Volvo S40 (2004–2013)2009–2010Tylko silnik: B4204S3, D4204T · Tylko skrzynia biegów: MPS6
- Volvo S40 (2004–2013)2011–2012Tylko silnik: B4204S3 · Tylko skrzynia biegów: MPS6
- Volvo V50 (2004–2013)2008Tylko silnik: D4204T · Tylko skrzynia biegów: MPS6
- Volvo V50 (2004–2013)2009–2010Tylko silnik: B4204S3, D4204T · Tylko skrzynia biegów: MPS6
- Volvo V50 (2004–2013)2011–2012Tylko silnik: B4204S3 · Tylko skrzynia biegów: MPS6
Co oznacza ten kod błędu?
The oil temperature sensor in the transmission gives a signal outside a predefined value. The transmission has temperature sensors that give the control module information about the temperature of the oil and of the electrical components.
Możliwe przyczyny
- The sensor is damaged
Co możesz zrobić
- 1Read out the fault codes from the transmission control module, such as another temperature fault code, and deal with those first
- 2With diagnostic equipment, compare the oil temperature from the sensors in live data with the room temperature while the transmission is cold
- 3After a short road test with some gear changes, read the oil temperature again; the temperature should have risen by about the same amount
- 4If the readings are not reasonable, the fault is permanent. If they are reasonable and match, it was probably present before but is not active now
- 5If the fault is inside the control module or its components, the mechatronic unit must be replaced, which a workshop should do
Objawy, które możesz zauważyć1
- No noticeable symptoms for the driver
Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.