VOLVO
TCM-P281500 - Pressure Control Solenoid "SL5" Control Circuit High. General Failure Information. No sub type information
Układ
Sterownik automatycznej skrzyni biegów (TCM)
Modele Volvo, których dotyczy ten kod błędu
Dotyczy następujących modeli:
9 modeliS60 (2011–), S80 (2007–), V40 (2013–), V40 Cross Country (2013–), V60 (2011–), V60 Cross Country (2015–), V70 (2008–), XC60 (2009–), XC70 (2008–)
Pokaż modele wg rocznika i silnika (9)
- Volvo S60 (2011–)2014–2015Tylko skrzynia biegów: TG-81SC
- Volvo S80 (2007–)2014–2015Tylko skrzynia biegów: TG-81SC
- Volvo V40 (2013–)2015Tylko skrzynia biegów: TG-81SC
- Volvo V40 Cross Country (2013–)2015Tylko skrzynia biegów: TG-81SC, TG-81SC AWD
- Volvo V60 (2011–)2014–2015Tylko skrzynia biegów: TG-81SC
- Volvo V60 Cross Country (2015–)2015Tylko skrzynia biegów: TG-81SC
- Volvo V70 (2008–)2014–2015Tylko skrzynia biegów: TG-81SC
- Volvo XC60 (2009–)2014–2015Tylko skrzynia biegów: TG-81SC
- Volvo XC70 (2008–)2014–2015Tylko skrzynia biegów: TG-81SC
Co oznacza ten kod błędu?
The transmission control module (TCM) has detected that the current in the circuit to linear pressure solenoid SL5 is higher than allowed. SL5 regulates the system pressure in the transmission, so the fault affects the gear changes. The cause may be a wire shorted to supply voltage, a damaged solenoid or an internal fault in the control module.
Możliwe przyczyny
- Contact resistance, oxidation or poor connection at the SL5 connector or joint
- Short to supply voltage in the wiring to SL5
- SL5 is stuck
- SL5 is damaged
- Internal fault in the transmission control system or in the TCM
Co możesz zrobić
- 1Read and note the code, clear it and road test the car to see whether it returns
- 2Check that the battery is in good condition and that the fuses are intact
- 3Check that the connectors at the transmission are fully engaged
- 4If the fault returns, have a workshop check SL5, the wiring and the control module, and replace the mechatronic unit if needed
Objawy, które możesz zauważyć5
- Message in the display
- The malfunction indicator lamp comes on or behaves abnormally
- Poor performance, the car lacks power
- No automatic gear changes
- No movement forward or in reverse with a gear selected
Na co może wpływać usterka3
- Gears that are not available are blocked
- Adaptation and neutral control are blocked
- Automatic engine start and stop is switched off
Ogólne wskazówki dla właścicieli. Diagnostyka na samochodzie może wskazać inną przyczynę.