What causes fault code P0570?

• Most likely: Faulty cruise control switch (internal short or oxidation) • Likely: Wiring issue or frayed wires in the steering column (clockspring failure) • Possible: High resistance in connectors between steering wheel and ECU • Rare: Software glitch or internal fault in the Steering Wheel Module (SWM)

Powertrain (Engine & Gearbox)Standard EOBD

P0570 - Cruise Control accel signal - invalid signal

Q: What are the symptoms of fault code P0570?

• Cruise control cannot be engaged • Check Engine Light (MIL) may illuminate • Dashboard message: 'Cruise control service required' • Inability to accelerate using steering wheel buttons

Q: How do you fix fault code P0570?

STEP 1: Visually inspect the steering wheel buttons for stickiness or damage. Clean with electronic contact cleaner if necessary. STEP 2: Use a diagnostic scan tool to monitor live data parameters for cruise control switches. Observe if the ECU registers the 'Set/Accel' command. If signal is erratic or missing, proceed to step 3. STEP 3: Measure voltage and resistance at the switch connector. Reference values are typically between 0.5V and 4.5V. Test the clockspring for continuity (should be <1 Ohm). STEP 4: Replace the faulty switch assembly or clockspring based on measurement results.

Last updated:1 February 2026

Related:Cruise Control Switch, Clockspring (Slepering), Steering Wheel Module (SWM), Engine Control Module (ECM), CAN-bus wiring

System

Powertrain (Engine & Gearbox)

Related Fault Codes

P0500

Vehicle Speed Sensor (VSS) 'A' Range/Performance

P0501

Vehicle Speed Sensor 'A' Range/Performance

P0502

Vehicle Speed Sensor 'A' Circuit Low Input

P0503

Vehicle Speed Sensor (VSS) Intermittent/Erratic/High

Technical Description

P0570 is stored when the Engine Control Module (ECM) detects an invalid or out-of-range voltage signal from the Cruise Control 'Set/Accel' switch. The system monitors the switch assembly through a resistive ladder network. If the return voltage does not match any predefined values for a specific period, the ECM flags an invalid signal and disables the cruise control system to ensure vehicle safety, often communicating this fault across the CAN bus.

Possible Causes

Faulty cruise control switch (internal short or oxidation)

Wiring issue or frayed wires in the steering column (clockspring failure)

High resistance in connectors between steering wheel and ECU

Software glitch or internal fault in the Steering Wheel Module (SWM)

Symptoms

Cruise control cannot be engaged

Check Engine Light (MIL) may illuminate

Dashboard message: 'Cruise control service required'

Inability to accelerate using steering wheel buttons

Do you also have
other fault codes?

See how P0570 connects with your other fault codes. Our advanced analysis tool identifies causal relationships and root causes directly.

Analyze multiple codes

P0570 - Cruise Control accel signal - invalid signal

Related Fault Codes

Technical Description

Possible Causes

Symptoms

Recommended Solution

Workflow

Mechanic's Tip

Do you also have
other fault codes?

P0570 - Cruise Control accel signal - invalid signal

Related Fault Codes

Technical Description

Possible Causes

Symptoms

Recommended Solution

Workflow

Mechanic's Tip

Do you also have other fault codes?

Do you also have
other fault codes?