P242A - Exhaust Gas Temperature Sensor (EGT) Circuit (Bank 1 Sensor '3')
System
Powertrain (Engine & Gearbox)
Technical Description
The control module has detected a fault in the Exhaust Gas Temperature Sensor (EGT) Circuit (Bank 1 Sensor '3') (P242A).
Multimeter Test Points & Nominal Values
| Test Point / Component | Measurement | Nominal Target Range | Test Condition |
|---|---|---|---|
| Exhaust Gas Temperature Sensor (EGT) Circuit (Bank 1 Sensor '3') – Signal Voltage | Voltage (V) | 0.50 - 4.50 V (tracks operating range) | Ignition ON, connector engaged |
| 5 V Reference Voltage | Voltage (V) | 4.95 - 5.05 V | Ignition ON at sensor connector |
| Sensor Ground Voltage Drop | Voltage (V) | < 0.05 V (< 50 mV) | Under load to chassis ground |
| Signal Wire Continuity | Resistance (Ω) | < 0.5 Ω (Open = OL) | Disconnected harness between sensor and ECM |
Ignition ON, connector engaged
Ignition ON at sensor connector
Under load to chassis ground
Disconnected harness between sensor and ECM
Oscilloscope Waveform Analysis
100 ms/div, 1 V/divPossible Causes
Bank 1 specific:Inspect wiring harness to cylinder bank 1 (firewall/right bank, exposed to exhaust manifold heat).
Chafed or pinched wiring harness along the signal path to Exhaust Gas Temperature Sensor (EGT) Circuit (Bank 1 Sensor '3')
Poor ground connection or excessive voltage drop (> 0.1 V) at the ground point for Exhaust Gas Temperature Sensor (EGT) Circuit (Bank 1 Sensor '3')
Defective internal output driver or reference circuit in the control module for Exhaust Gas Temperature Sensor (EGT) Circuit (Bank 1 Sensor '3')
Symptoms
4
Recommended Solution
Cross-swap the component on Bank 1 with Bank 2 to rule out mechanical oil passages and internal timing wear.
Review freeze-frame environmental data and perform fundamental voltage-drop and resistance checks on the circuit.
Verify loaded supply voltage and harness terminal pins at Exhaust Gas Temperature Sensor (EGT) Circuit (Bank 1 Sensor '3').
Check circuit continuity and ground-side voltage drop (< 0.05 V) for Exhaust Gas Temperature Sensor (EGT) Circuit (Bank 1 Sensor '3').
Unplug the sensor:the signal must swing to a known rail. Replace the sensor or repair the wiring based on the result.
Mechanic's Tip
Always run a loaded voltage-drop test on the sensor ground with ignition ON. A drop above 0.1 V shifts the whole signal and tricks the module into setting sensor codes on a good sensor.
Related Fault Codes
Exhaust Temperature Too Low For Particulate Filter Regeneration (Bank 2)
Oxygen Sensor (O2) Signals Swapped Bank 2 Sensor '2' / Bank 2 Sensor '3'
Evaporative Emission System (EVAP) Leak Detection Pump Pressure Sensor Range/Performance
Evaporative Emission System (EVAP) Leak Detection Pump Sense Range/Performance