VOLVO
BCM-C10111F - Brake Pedal Feel Simulator Cut-off Pressure Sensor. General Electrical Failures. Circuit intermittent
System
Brake Control Module (BCM)
Volvo models this fault code applies to
Applies to the following models:
1 modelV60 (2011–)
Show models by year and engine (2)
What does this fault code mean?
On the V60, the brake control module (BCM) received an incorrect signal from the pressure sensor in the cut-off unit, which belongs to the brake pedal feel simulator, at start-up. The signal is checked when the car is started, and the fault may have been temporary, but the connector and wiring should still be checked.
Possible causes
- Damaged wiring to the cut-off unit
- Faulty plug contact at the cut-off unit's pressure sensor
- Damaged pressure sensor in the cut-off unit
What you can do
- 1Read and note the code, clear it and road test the car to see whether it returns
- 2Look for damage in the wiring to the cut-off unit and in the connector at the pressure sensor
- 3Check the pressure sensor with diagnostic equipment and replace it if damaged
- 4The braking system is safety critical: do not work on the cut-off unit or brake pedal yourself; leave this to a workshop, and drive carefully until the fault is fixed
Symptoms you may notice3
- Anti-spin function does not work
- Hill descent assist does not work
- Front monitoring and adaptive cruise control do not work
General guidance for car owners. Diagnosis on the car can point to a different cause.