VOLVO
CEM-B102651 - Steering Column Lock. System Programming Failures. Not programmed
System
Central Electronic Module (CEM)
Volvo models this fault code applies to
Applies to the following models:
8 modelsS60 (2011–), S80 (2007–), V40 (2013–), V40 Cross Country (2013–), V60 (2011–), V70 (2008–), XC60 (2009–), XC70 (2008–)
What does this fault code mean?
The central electronic module (CEM) has found that the steering column lock control unit (SCL) is not programmed. The fault code is stored at start attempts. It can follow an earlier programming that went wrong, or a control unit replacement made without programming.
Possible causes
- Steering column lock control unit (SCL) is not programmed
What you can do
- 1The steering lock is part of the steering. Do not drive the car if it does not unlock or sticks; have a workshop check it
- 2If the steering lock control unit has been replaced, by you or at a workshop, it must be programmed. Ask the workshop to check this
- 3Programming and software loading of the steering lock control unit is a workshop task
- 4Clear the fault code once programming is finished, then road test to confirm that the steering lock and starting work
Symptoms you may notice4
- The starter motor does not turn over
- The steering column lock does not lock or does not unlock
- The engine does not start, or starts only unreliably
- Amber symbol and text message in the display
General guidance for car owners. Diagnosis on the car can point to a different cause.