VOLVO
CEM-B10AD96 - Rain sensor. Component Failures. Component internal failure
System
Central Electronic Module (CEM)
Volvo models this fault code applies to
Applies to the following models:
2 modelsV40 (2013–), V40 Cross Country (2013–)
Show models by year and engine (2)
What does this fault code mean?
The CEM communicates with the rain sensor, which also has an integrated light sensor that controls the dipped beam when the light switch is in auto mode. The fault shows that the light sensor inside the rain sensor has an internal fault.
Possible causes
- Damaged rain sensor
- The rain sensor is not firmly attached to the glass
- Crack in the glass near the rain sensor
- Stone chip in the glass near the rain sensor
What you can do
- 1Read off and note the code, clear it and check whether it returns when you drive with the light switch in auto mode
- 2Check that the rain sensor is firmly attached and has good contact with the glass and its cushion
- 3Look for cracks or stone chips in the glass near the rain sensor
- 4If you have a diagnostic tool, read the light value from the rain sensor in live data while you move between light and dark
- 5If the fault remains, have a workshop replace the rain sensor
Symptoms you may notice1
- The automatic dipped beam control does not work
What the fault can affect1
- The dipped beam stays on at all times when the light switch is in auto mode
General guidance for car owners. Diagnosis on the car can point to a different cause.