VOLVO
CEM-B10F401 - Right front position light. General Failure Information. No sub type information
System
Central Electronic Module (CEM)
Volvo models this fault code applies to
Applies to the following models:
4 modelsS80 (2007–), V70 (2008–), XC60 (2009–), XC70 (2008–)
Show models by year and engine (4)
What does this fault code mean?
The CEM feeds the right front position light directly from an output. The code is stored when the supply cable has a break or is shorted to ground. The right front position light then does not work.
Possible causes
- The supply cable is short-circuited to ground
- Open circuit in the supply cable
What you can do
- 1Check that the relevant fuses are intact. Their locations are in the owner's manual or on the fuse box cover
- 2Check that the lamp is secure and that the connectors in the lamp housing are clean and dry
- 3Look for chafing and pinch damage on the supply cable to the right front position light
- 4Use a multimeter to check that the supply cable has no contact with ground (the body)
- 5Use a multimeter to check that the supply cable is not broken
- 6If the fault returns, have a workshop with diagnostic equipment check the control module output and the wiring
Symptoms you may notice1
- Right front position light does not work
What the fault can affect3
- The output switches off in the driving cycle in which the fault is detected
- If the fault remains, the output switches off permanently after 100 driving cycles
- Clearing the fault codes and starting a new driving cycle resets the output
General guidance for car owners. Diagnosis on the car can point to a different cause.