VOLVO
DDM-B11B815 - Driver Blind Spot Warning Indicator Supply. General Electrical Failures. Circuit short to battery or open
System
Driver Door Module (DDM)
Volvo models this fault code applies to
Applies to the following models:
4 modelsS80 (2007–), V70 (2008–), XC60 (2009–), XC70 (2008–)
Show models by year and engine (4)
What does this fault code mean?
The fault is stored when the output signal to the driver-side camera is too high. On cars with the blind spot system (BLIS) a camera is fitted in each external mirror. The cause can be a supply cable short-circuited to voltage or an open circuit, and the LED then does not light.
Possible causes
- Supply cable short-circuited to voltage
- Open circuit in the supply cable
What you can do
- 1Read out and note the fault code, clear it, then test drive the car to see if it returns
- 2With ignition off, use a multimeter to check that the supply cable to the camera has no contact with plus and is not broken. Replace the cable if it is damaged
- 3Check the connectors in the driver's side mirror for oxidation and loose contacts
- 4If you have a diagnostic tool, activate the blind spot system on the driver's side and check whether the camera responds
- 5If no fault is found, have a workshop check the camera in the driver's side mirror
Symptoms you may notice2
- LED does not light
- A message appears in the information display
General guidance for car owners. Diagnosis on the car can point to a different cause.