VOLVO
DIM-U210000 - Control Module Not Configured. General Failure Information. No sub type information
System
Driver Information Module (DIM)
Volvo models this fault code applies to
Applies to the following models:
9 modelsS60 (2011–), S80 (2007–), V40 (2013–), V40 Cross Country (2013–), V60 (2011–), V60 Cross Country (2015–), V70 (2008–), XC60 (2009–), XC70 (2008–)
What does this fault code mean?
The instrument cluster (DIM) has found that it is not configured for the car. Because the information about the car's configuration is missing, some warnings, gauges and functions may show faults. The fault can be caused by the software in the instrument cluster or in the central electronic module, and
Possible causes
- The instrument cluster is not configured for the car
What you can do
- 1Read the fault codes and check whether the code for the central electronic module (CEM) is also stored, as the configuration may come from there
- 2Check that the fuses are intact. Their location is in the owner's manual or the fuse list
- 3Check that the connectors to the instrument cluster and to the central electronic module are fully engaged
- 4Have a workshop check and, if needed, load new software into the central electronic module and then into the instrument cluster
- 5After the workshop has done this, switch the ignition off, switch it on again and check that the code does not return
Symptoms you may notice4
- A warning lamp comes on or behaves abnormally
- A text or warning symbol appears in the instrument cluster
- The trip computer does not work
- One or more gauges show faults or do not work
General guidance for car owners. Diagnosis on the car can point to a different cause.