VOLVO
ECM-222B - Rear heated oxygen sensor (HO2S), bank 1. Signal missing
System
Engine Control Module (ECM)
Volvo models this fault code applies to
Applies to the following models:
9 modelsC30 (2007–2013), C70 (2006–2013), S40 (2004–2013), S60 (2001–2009), S80 (1999–2006), V50 (2004–2013), V70 (2000–2008), V70 XC / XC70 (2001–2007), XC90 (2003–)
Show models by year and engine (23)
- Volvo C30 (2007–2013)2007Engine B5254T3 only
- Volvo C30 (2007–2013)2008–2013Engine B5254T7 only
- Volvo C70 (2006–2013)2006–2007Engine B5254T3 only
- Volvo C70 (2006–2013)2008–2013Engine B5254T7 only
- Volvo S40 (2004–2013)2005–2007Engine B5254T3 only
- Volvo S40 (2004–2013)2008Engine B5254T3, B5254T7 only
- Volvo S40 (2004–2013)2009–2012Engine B5254T7 only
- Volvo S60 (2001–2009)2005–2006Engine B5204T5, B5244T4, B5244T5, B5254T2, B5254T4 only
- Volvo S60 (2001–2009)2007Engine B5204T5, B5244T5, B5254T2, B5254T4 only
- Volvo S60 (2001–2009)2008–2009Engine B5204T5, B5244T5, B5254T2 only
- Volvo S80 (1999–2006)2005–2006Engine B5204T5, B5244T4, B5254T2, B6294S2, B6294T only
- Volvo V50 (2004–2013)2005–2007Engine B5254T3 only
- Volvo V50 (2004–2013)2008–2012Engine B5254T7 only
- Volvo V70 (2000–2008)2005Engine B5204T5, B5244T4, B5244T5, B5254T2, B5254T4 only
- Volvo V70 (2000–2008)2006–2007Engine B5204T5, B5244T5, B5254T2, B5254T4 only
- Volvo V70 (2000–2008)2008Engine B5254T2 only
- Volvo V70 XC / XC70 (2001–2007)2005All engines except: D5244T
- Volvo V70 XC / XC70 (2001–2007)2006Engine B5244T4, B5254T2 only
- Volvo V70 XC / XC70 (2001–2007)2007Engine B5254T2 only
- Volvo XC90 (2003–)2005–2006Engine B5254T2, B6294T only
- Volvo XC90 (2003–)2007–2012Engine B5254T2 only
- Volvo XC90 (2003–)2013–2014Engine B5254T9 only
- Volvo XC90 (2003–)2015
What does this fault code mean?
The engine control module (ECM) monitors the signal from the rear oxygen sensor on bank 1, the sensor after the catalytic converter. The code is set when the signal is missing or outside its permitted range, or when the sensor heater disturbs the signal. Rear oxygen sensor control is then switched off, and so is the check of the catalytic converter.
Possible causes
- Poor contact or oxidation in the sensor connector
- Open circuit in the signal or ground wire between the sensor and the engine control module
- Signal wire short-circuited to ground
- Damaged rear oxygen sensor
What you can do
- 1Read the code, note it, clear it and road test to see whether it returns
- 2Check that the connector at the rear oxygen sensor is secure and free from corrosion and oxidation
- 3Follow the wire from the sensor and look for chafing, breaks or loose clips, especially where it runs under the car
- 4If you have a diagnostic tool: watch the oxygen sensor signal in live data while the engine runs and see whether the value changes
- 5Use a multimeter to check that the signal wire is not shorted to ground and has continuity all the way from the sensor
- 6If the fault remains after these checks, have a workshop decide whether the sensor needs replacing
Symptoms you may notice1
- Malfunction indicator lamp (MIL) lit
What the fault can affect2
- Rear oxygen sensor control after the catalytic converter is switched off
- The catalytic converter cannot be checked
General guidance for car owners. Diagnosis on the car can point to a different cause.