VOLVO
ECM-222C - Rear heated oxygen sensor (HO2S), bank 1. Signal too high
System
Engine Control Module (ECM)
Volvo models this fault code applies to
Applies to the following models:
9 modelsC30 (2007–2013), C70 (2006–2013), S40 (2004–2013), S60 (2001–2009), S80 (1999–2006), V50 (2004–2013), V70 (2000–2008), V70 XC / XC70 (2001–2007), XC90 (2003–)
Show models by year and engine (23)
- Volvo C30 (2007–2013)2007Engine B5254T3 only
- Volvo C30 (2007–2013)2008–2013Engine B5254T7 only
- Volvo C70 (2006–2013)2006–2007Engine B5254T3 only
- Volvo C70 (2006–2013)2008–2013Engine B5254T7 only
- Volvo S40 (2004–2013)2005–2007Engine B5254T3 only
- Volvo S40 (2004–2013)2008Engine B5254T3, B5254T7 only
- Volvo S40 (2004–2013)2009–2012Engine B5254T7 only
- Volvo S60 (2001–2009)2005–2006Engine B5204T5, B5244T4, B5244T5, B5254T2, B5254T4 only
- Volvo S60 (2001–2009)2007Engine B5204T5, B5244T5, B5254T2, B5254T4 only
- Volvo S60 (2001–2009)2008–2009Engine B5204T5, B5244T5, B5254T2 only
- Volvo S80 (1999–2006)2005–2006Engine B5204T5, B5244T4, B5254T2, B6294S2, B6294T only
- Volvo V50 (2004–2013)2005–2007Engine B5254T3 only
- Volvo V50 (2004–2013)2008–2012Engine B5254T7 only
- Volvo V70 (2000–2008)2005Engine B5204T5, B5244T4, B5244T5, B5254T2, B5254T4 only
- Volvo V70 (2000–2008)2006–2007Engine B5204T5, B5244T5, B5254T2, B5254T4 only
- Volvo V70 (2000–2008)2008Engine B5254T2 only
- Volvo V70 XC / XC70 (2001–2007)2005All engines except: D5244T
- Volvo V70 XC / XC70 (2001–2007)2006Engine B5244T4, B5254T2 only
- Volvo V70 XC / XC70 (2001–2007)2007Engine B5254T2 only
- Volvo XC90 (2003–)2005–2006Engine B5254T2, B6294T only
- Volvo XC90 (2003–)2007–2012Engine B5254T2 only
- Volvo XC90 (2003–)2013–2014Engine B5254T9 only
- Volvo XC90 (2003–)2015
What does this fault code mean?
The signal from the rear oxygen sensor on bank 1 is above its permitted range. The fault can come from the signal wire or the ground wire touching a live voltage, or from a damaged sensor. Rear oxygen sensor control after the catalytic converter is switched off for as long as the fault is present.
Possible causes
- Signal wire short-circuited to supply voltage
- Ground wire short-circuited to supply voltage
- Damaged rear oxygen sensor
What you can do
- 1Read and clear the code, then road test to see whether it returns
- 2Follow the signal wire from the sensor and look for chafe points or places where it may have touched a live wire
- 3Unplug the sensor connector and use a multimeter: voltage on the signal wire to ground with the ignition on means a short to supply
- 4If you have a diagnostic tool: check in live data whether the oxygen sensor signal sticks at a high value while the engine runs
- 5If the fault remains after these checks, have a workshop decide whether the sensor should be replaced
Symptoms you may notice1
- Malfunction indicator lamp (MIL) lit
What the fault can affect2
- Rear oxygen sensor control after the catalytic converter is switched off
- The catalytic converter cannot be checked
General guidance for car owners. Diagnosis on the car can point to a different cause.