VOLVO
ECM-2314 - Injector 4. Faulty signal
System
Engine Control Module (ECM)
Volvo models this fault code applies to
Applies to the following models:
5 modelsS60 (2001–2009), S80 (1999–2006), V70 (2000–2008), V70 XC / XC70 (2001–2007), XC90 (2003–)
Show models by year and engine (10)
- Volvo S60 (2001–2009)2001Engine D5244T only
- Volvo S60 (2001–2009)2002–2003, 2006Engine D5244T, D5244T2 only
- Volvo S60 (2001–2009)2004–2005Engine D5244T, D5244T2, D5244T3 only
- Volvo S80 (1999–2006)2001Engine D5244T only
- Volvo S80 (1999–2006)2002–2006Engine D5244T, D5244T2 only
- Volvo V70 (2000–2008)2001Engine D5244T only
- Volvo V70 (2000–2008)2002–2003, 2006Engine D5244T, D5244T2 only
- Volvo V70 (2000–2008)2004–2005Engine D5244T, D5244T2, D5244T3 only
- Volvo V70 XC / XC70 (2001–2007)2003–2006Engine D5244T only
- Volvo XC90 (2003–)2003–2006Engine D5244T only
What does this fault code mean?
The engine control module (ECM) has found an electrical fault in the circuit to injector 4 while the engine was running. Each injector is driven by its own power stage inside the engine control module. The equivalent codes for the other cylinders are ECM-2311 to ECM-2315.
Possible causes
- Open or short circuit in the wiring to injector 4
- Poor contact or corrosion in the injector connector
- Faulty injector
- Supply voltage problem, such as loose battery terminals or a charging fault
- Faulty engine control module
What you can do
- 1Check the battery terminals and that the battery and charging system work
- 2Check the injector 4 connector for poor contact, oil contamination and corrosion
- 3Inspect the injector wiring for heat or chafing damage
- 4Have a workshop test the injector and wiring; replace the injector if it is faulty
Symptoms you may notice2
- The engine does not run on all cylinders – rough running and reduced power
- The engine may be hard to start or not start
General guidance for car owners. Diagnosis on the car can point to a different cause.