VOLVO
ECM-243B - Front heated oxygen sensor (HO2S), bank 1. Signal missing
System
Engine Control Module (ECM)
Volvo models this fault code applies to
Applies to the following models:
9 modelsC30 (2007–2013), C70 (2006–2013), S40 (2004–2013), S60 (2001–2009), S80 (1999–2006), V50 (2004–2013), V70 (2000–2008), V70 XC / XC70 (2001–2007), XC90 (2003–)
Show models by year and engine (23)
- Volvo C30 (2007–2013)2007Engine B5254T3 only
- Volvo C30 (2007–2013)2008–2013Engine B5254T7 only
- Volvo C70 (2006–2013)2006–2007Engine B5254T3 only
- Volvo C70 (2006–2013)2008–2013Engine B5254T7 only
- Volvo S40 (2004–2013)2005–2007Engine B5254T3 only
- Volvo S40 (2004–2013)2008Engine B5254T3, B5254T7 only
- Volvo S40 (2004–2013)2009–2012Engine B5254T7 only
- Volvo S60 (2001–2009)2005–2006Engine B5204T5, B5244T4, B5244T5, B5254T2, B5254T4 only
- Volvo S60 (2001–2009)2007Engine B5204T5, B5244T5, B5254T2, B5254T4 only
- Volvo S60 (2001–2009)2008–2009Engine B5204T5, B5244T5, B5254T2 only
- Volvo S80 (1999–2006)2005–2006Engine B5204T5, B5244T4, B5254T2, B6294S2, B6294T only
- Volvo V50 (2004–2013)2005–2007Engine B5254T3 only
- Volvo V50 (2004–2013)2008–2012Engine B5254T7 only
- Volvo V70 (2000–2008)2005Engine B5204T5, B5244T4, B5244T5, B5254T2, B5254T4 only
- Volvo V70 (2000–2008)2006–2007Engine B5204T5, B5244T5, B5254T2, B5254T4 only
- Volvo V70 (2000–2008)2008Engine B5254T2 only
- Volvo V70 XC / XC70 (2001–2007)2005All engines except: D5244T
- Volvo V70 XC / XC70 (2001–2007)2006Engine B5244T4, B5254T2 only
- Volvo V70 XC / XC70 (2001–2007)2007Engine B5254T2 only
- Volvo XC90 (2003–)2005–2006Engine B5254T2, B6294T only
- Volvo XC90 (2003–)2007–2012Engine B5254T2 only
- Volvo XC90 (2003–)2013–2014Engine B5254T9 only
- Volvo XC90 (2003–)2015
What does this fault code mean?
Although the code is titled signal missing, it applies when the voltage for the oxygen sensor heater disturbs the sensor signal. The ECM watches the signal from the front sensor on bank 1 and stores the code when the heater voltage affects it.
Possible causes
- Short circuit between one of the heater cables for the oxygen sensor and the sensor's other signal cables
- Damaged front heated oxygen sensor
What you can do
- 1Read the code, clear it and road test to see whether it returns
- 2Make sure the oxygen sensor connector is fully engaged and clean. Do not use rust solvent spray or grease in it
- 3Follow the cables from the oxygen sensor and look for chafing and damaged insulation, especially near the exhaust pipe
- 4Use a multimeter to check that the heater cables are not short-circuited to the sensor's other signal cables
- 5If the cables are intact, have a workshop with diagnostic equipment decide whether the oxygen sensor needs replacing
Symptoms you may notice1
- The malfunction indicator lamp (MIL) is lit
What the fault can affect2
- Oxygen sensor control is switched off
- Catalytic converter diagnostics are switched off
General guidance for car owners. Diagnosis on the car can point to a different cause.