VOLVO
ECM-280D - Fuel pressure sensor. Signal too low
System
Engine Control Module (ECM)
Volvo models this fault code applies to
Applies to the following models:
9 modelsC30 (2007–2013), C70 (2006–2013), S40 (2004–2013), S60 (2001–2009), S80 (1999–2006), V50 (2004–2013), V70 (2000–2008), V70 XC / XC70 (2001–2007), XC90 (2003–)
Show models by year and engine (23)
- Volvo C30 (2007–2013)2007Engine B5254T3 only
- Volvo C30 (2007–2013)2008–2013Engine B5254T7 only
- Volvo C70 (2006–2013)2006–2007Engine B5254T3 only
- Volvo C70 (2006–2013)2008–2013Engine B5254T7 only
- Volvo S40 (2004–2013)2005–2007Engine B5254T3 only
- Volvo S40 (2004–2013)2008Engine B5254T3, B5254T7 only
- Volvo S40 (2004–2013)2009–2012Engine B5254T7 only
- Volvo S60 (2001–2009)2005–2006Engine B5204T5, B5244T4, B5244T5, B5254T2, B5254T4 only
- Volvo S60 (2001–2009)2007Engine B5204T5, B5244T5, B5254T2, B5254T4 only
- Volvo S60 (2001–2009)2008–2009Engine B5204T5, B5244T5, B5254T2 only
- Volvo S80 (1999–2006)2005–2006Engine B5204T5, B5244T4, B5254T2, B6294S2, B6294T only
- Volvo V50 (2004–2013)2005–2007Engine B5254T3 only
- Volvo V50 (2004–2013)2008–2012Engine B5254T7 only
- Volvo V70 (2000–2008)2005Engine B5204T5, B5244T4, B5244T5, B5254T2, B5254T4 only
- Volvo V70 (2000–2008)2006–2007Engine B5204T5, B5244T5, B5254T2, B5254T4 only
- Volvo V70 (2000–2008)2008Engine B5254T2 only
- Volvo V70 XC / XC70 (2001–2007)2005All engines except: D5244T
- Volvo V70 XC / XC70 (2001–2007)2006Engine B5244T4, B5254T2 only
- Volvo V70 XC / XC70 (2001–2007)2007Engine B5254T2 only
- Volvo XC90 (2003–)2005–2006Engine B5254T2, B6294T only
- Volvo XC90 (2003–)2007–2012Engine B5254T2 only
- Volvo XC90 (2003–)2013–2014Engine B5254T9 only
- Volvo XC90 (2003–)2015
What does this fault code mean?
The engine control module (ECM) has detected a fuel pressure sensor signal that is lower than it should be. Possible causes include poor connector contact, an open or short circuit in the wiring, or a damaged fuel pressure sensor.
Possible causes
- Contact resistance or oxide in the terminals
- Signal cable shorted to supply voltage
- Open circuit in the signal cable
- Open circuit in the signal ground wire
- Signal cable shorted to ground
- Damaged fuel pressure sensor
What you can do
- 1Read and note the code, clear it, warm the engine and see whether it returns
- 2If you have a diagnostic tool: check the fuel pressure value in live data with the engine running and see whether it looks too low or stays still
- 3Check that the connector at the fuel pressure sensor is secure and free from contact resistance and oxide
- 4With the car switched off, use a multimeter to check that the signal cable is not broken and not shorted to ground
- 5Check the signal ground wire for an open circuit
- 6If no damage or connector fault is visible, have a workshop try a new fuel pressure sensor and check that the fault clears
Symptoms you may notice5
- Engine lacks power when moving off from standstill
- Engine may stall at any time
- Engine hesitates, surges or runs unevenly under acceleration and when slowing down
- Engine is hard to start, cranks slowly or does not start at all
- Check engine lamp (Malfunction Indicator Light) comes on or behaves abnormally
General guidance for car owners. Diagnosis on the car can point to a different cause.