VOLVO
ECM-290D - Fuel pressure. Signal too low
System
Engine Control Module (ECM)
Volvo models this fault code applies to
Applies to the following models:
9 modelsC30 (2007–2013), C70 (2006–2013), S40 (2004–2013), S60 (2001–2009), S80 (1999–2006), V50 (2004–2013), V70 (2000–2008), V70 XC / XC70 (2001–2007), XC90 (2003–)
Show models by year and engine (23)
- Volvo C30 (2007–2013)2007Engine B5254T3 only
- Volvo C30 (2007–2013)2008–2013Engine B5254T7 only
- Volvo C70 (2006–2013)2006–2007Engine B5254T3 only
- Volvo C70 (2006–2013)2008–2013Engine B5254T7 only
- Volvo S40 (2004–2013)2005–2007Engine B5254T3 only
- Volvo S40 (2004–2013)2008Engine B5254T3, B5254T7 only
- Volvo S40 (2004–2013)2009–2012Engine B5254T7 only
- Volvo S60 (2001–2009)2005–2006Engine B5204T5, B5244T4, B5244T5, B5254T2, B5254T4 only
- Volvo S60 (2001–2009)2007Engine B5204T5, B5244T5, B5254T2, B5254T4 only
- Volvo S60 (2001–2009)2008–2009Engine B5204T5, B5244T5, B5254T2 only
- Volvo S80 (1999–2006)2005–2006Engine B5204T5, B5244T4, B5254T2, B6294S2, B6294T only
- Volvo V50 (2004–2013)2005–2007Engine B5254T3 only
- Volvo V50 (2004–2013)2008–2012Engine B5254T7 only
- Volvo V70 (2000–2008)2005Engine B5204T5, B5244T4, B5244T5, B5254T2, B5254T4 only
- Volvo V70 (2000–2008)2006–2007Engine B5204T5, B5244T5, B5254T2, B5254T4 only
- Volvo V70 (2000–2008)2008Engine B5254T2 only
- Volvo V70 XC / XC70 (2001–2007)2005All engines except: D5244T
- Volvo V70 XC / XC70 (2001–2007)2006Engine B5244T4, B5254T2 only
- Volvo V70 XC / XC70 (2001–2007)2007Engine B5254T2 only
- Volvo XC90 (2003–)2005–2006Engine B5254T2, B6294T only
- Volvo XC90 (2003–)2007–2012Engine B5254T2 only
- Volvo XC90 (2003–)2013–2014Engine B5254T9 only
- Volvo XC90 (2003–)2015
What does this fault code mean?
The engine control module controls the fuel pressure through the fuel pump control module. The code is set when the measured fuel pressure stays too low compared with the requested pressure for a certain time. The fault can be noticed while the engine runs and while it idles.
Possible causes
- Leakage at the fuel lines
- Blocked fuel filter
- Debris or loose particles inside the fuel tank
- Damaged fuel pressure sensor
- Damaged fuel pump
- Damaged fuel pump control module
What you can do
- 1Look up stored codes for the pressure sensors on the fuel and atmosphere side, and deal with those first
- 2Make sure the fuel level is not nearly empty, as there may then be too little fuel at the pump
- 3Look for leaks in the fuel lines and check that the fuel filter is not clogged
- 4Check the connectors at the fuel pressure sensor and at the pump control module for contact resistance and oxidation
- 5If you have a diagnostic tool: read the relative fuel pressure in live data with the engine warm and idling, and compare it with the target value the control module shows
- 6If no cause is found, have a workshop try a new fuel pump and check whether the fault clears
Symptoms you may notice5
- Engine lacks power, especially when moving off from standstill
- Engine may stall at any time
- Engine hesitates or surges when holding a steady speed
- Engine is hard to start or does not start at all
- Check engine lamp comes on or behaves abnormally
General guidance for car owners. Diagnosis on the car can point to a different cause.