VOLVO
ECM-639A - Injector class not programmed. Configuration fault
System
Engine Control Module (ECM)
Volvo models this fault code applies to
Applies to the following models:
5 modelsS60 (2001–2009), S80 (1999–2006), V70 (2000–2008), V70 XC / XC70 (2001–2007), XC90 (2003–)
Show models by year and engine (10)
- Volvo S60 (2001–2009)2001Engine D5244T only
- Volvo S60 (2001–2009)2002–2003, 2006Engine D5244T, D5244T2 only
- Volvo S60 (2001–2009)2004–2005Engine D5244T, D5244T2, D5244T3 only
- Volvo S80 (1999–2006)2001Engine D5244T only
- Volvo S80 (1999–2006)2002–2006Engine D5244T, D5244T2 only
- Volvo V70 (2000–2008)2001Engine D5244T only
- Volvo V70 (2000–2008)2002–2003, 2006Engine D5244T, D5244T2 only
- Volvo V70 (2000–2008)2004–2005Engine D5244T, D5244T2, D5244T3 only
- Volvo V70 XC / XC70 (2001–2007)2003–2006Engine D5244T only
- Volvo XC90 (2003–)2003–2006Engine D5244T only
What does this fault code mean?
The engine control module (ECM) lacks the optimizing parameters for the injectors, which must match the injector class. It is a configuration fault: the parameters need to be entered into the control module.
Possible causes
- Optimizing parameters are not programmed
What you can do
- 1Have a workshop program in the optimizing parameters that match the injector class
- 2If the injectors or the engine control module have been replaced, have the workshop check afterwards that the programming matches
- 3Clear the code after programming and see whether it returns
Symptoms you may notice1
- No noticeable symptoms for the driver
General guidance for car owners. Diagnosis on the car can point to a different cause.