VOLVO
ECM-P003E00 - Intake (A) Camshaft Profile Control Performance or Stuck Off (Bank 2). General Failure Information. No sub type information
System
Engine Control Module (ECM)
Volvo models this fault code applies to
Applies to the following models:
5 modelsS80 (2007–), V70 (2008–), XC60 (2009–), XC70 (2008–), XC90 (2003–)
Show models by year and engine (10)
- Volvo S80 (2007–)2007–2010Engine B6324S only
- Volvo S80 (2007–)2011–2015Engine B6324S5 only
- Volvo V70 (2008–)2008–2010Engine B6324S only
- Volvo V70 (2008–)2011–2014Engine B6324S5 only
- Volvo XC60 (2009–)2010Engine B6324S only
- Volvo XC60 (2009–)2011–2015Engine B6324S5 only
- Volvo XC70 (2008–)2008–2010Engine B6324S only
- Volvo XC70 (2008–)2011–2015Engine B6324S5 only
- Volvo XC90 (2003–)2007–2010Engine B6324S only
- Volvo XC90 (2003–)2011–2014Engine B6324S5 only
What does this fault code mean?
The intake cam profile control (A) is not working as it should on bank 2, which covers cylinders 3, 5 and 6. Intake manifold pressure is higher than expected for bank 2 compared with bank 1.
Possible causes
- Dirty or damaged cam profile solenoid
- Blocked oil passages for the variable cam profile
What you can do
- 1Read the fault code with a diagnostic tool and see whether it is active or only stored
- 2If you have a diagnostic tool, activate the bank 2 solenoid and check that it responds
- 3Check the connector and wiring to the bank 2 solenoid for looseness, corrosion and damage
- 4Impurities or cast debris in the oil can make the solenoid stick. Cleaning is usually enough, but a workshop should do it because the solenoid is removed
- 5Replace the solenoid if the fault remains after two cleanings
Symptoms you may notice4
- Malfunction indicator lamp (MIL) lights up
- Uneven idle
- Engine is hard to start
- Poor performance
What the fault can affect1
- Both banks of the variable cam profile end up in low lift
General guidance for car owners. Diagnosis on the car can point to a different cause.