ECM-P013416
VOLVO
ECM-P013416 - O2 Sensor Circuit No Activity Detected (Bank 1 Sensor 1). General Electrical Failures. Circuit voltage below threshold
System
Engine Control Module (ECM)
Volvo models this fault code applies to
Applies to the following models:
5 modelsS60 (2011–), S80 (2007–), V60 (2011–), V70 (2008–), XC60 (2009–)
Show models by year and engine (12)
- Volvo S60 (2011–)2011Engine B4204T6, B4204T7 only
- Volvo S60 (2011–)2012–2014Engine B4204T7 only
- Volvo S80 (2007–)2010Engine B4204T6 only
- Volvo S80 (2007–)2011–2014Engine B4204T6, B4204T7 only
- Volvo V60 (2011–)2011Engine B4204T6, B4204T7 only
- Volvo V60 (2011–)2012–2014Engine B4204T7 only
- Volvo V70 (2008–)2010Engine B4204T6 only
- Volvo V70 (2008–)2011Engine B4204T6, B4204T7 only
- Volvo V70 (2008–)2012–2014Engine B4204T7 only
- Volvo XC60 (2009–)2010Engine B4204T6 only
- Volvo XC60 (2009–)2011–2012Engine B4204T6, B4204T7 only
- Volvo XC60 (2009–)2013–2015Engine B4204T7 only
What does this fault code mean?
Although the code is named for a low voltage, it is set when the signal from the front oxygen sensor in bank 1 is outside its permitted operating range, or when the sensor's pre-heating voltage disturbs the signal. The engine control module (ECM) monitors the sensor signal while driving and only sets the code once the test has started and the conditions are met.
Possible causes
- Signal wire shorted to the pre-heating circuit
- Ground wire shorted to the pre-heating circuit
- Damaged front oxygen sensor
What you can do
- 1Read the code, clear it and road test the car to see whether it comes back
- 2Use a multimeter to check that the wires to the oxygen sensor are not shorted to each other, especially the signal wire against the pre-heating wires
- 3Check that the ground wire to the oxygen sensor is not shorted to the pre-heating circuit
- 4If you have a diagnostic tool: read the oxygen sensor signal in live data with the engine running and check that it is not stuck outside the normal range
- 5If the wiring is intact, replace the front oxygen sensor
Symptoms you may notice1
- Check engine light (MIL) on
What the fault can affect2
- Front oxygen sensor control is switched off
- Catalytic converter diagnostics are disabled
General guidance for car owners. Diagnosis on the car can point to a different cause.