What does fault code ECM-P014100 mean?

Diagnostic fault code details for ECM-P014100 (Volvo S60 (2011–), Volvo S60 (2011–), Volvo S60 (2011–)). Repair service at OBD Tuning.

VOLVO

ECM-P014100 - O2 Sensor Heater Circuit (Bank 1 Sensor 2). General Failure Information. No sub type information

System

Engine Control Module (ECM)

Volvo models this fault code applies to

This fault code has different meanings depending on model, model year or engine. Select the meaning that applies to your car.

Applies to the following models:

7 models

S60 (2011–), S80 (2007–), V40 (2013–), V40 Cross Country (2013–), V60 (2011–), V70 (2008–), XC60 (2009–)

Show models by year and engine (20)

What does this fault code mean?

The engine control module (ECM) monitors the rear oxygen sensor by checking its signal while driving. The code is set when the signal deviates from its permitted range, or when the sensor's pre-heating voltage disturbs the signal from the sensor. The fault may therefore lie in the sensor's heater.

Possible causes

Damaged rear oxygen sensor

What you can do

1Read the code, clear it and road test the car to see whether it comes back
2Check the connector to the rear sensor for contact resistance and oxidation; do not use rust solvent spray or grease
3Use a multimeter to check that the wires to the sensor have no open circuit and are not shorted to each other
4If the connector and wires are intact, replace the rear oxygen sensor

Symptoms you may notice1

Check engine light (MIL) on

What the fault can affect1

Control with the rear oxygen sensor is switched off

General guidance for car owners. Diagnosis on the car can point to a different cause.

VOLVO

ECM-P014100 - O2 Sensor Heater Circuit (Bank 1 Sensor 2). General Failure Information. No sub type information

System

Engine Control Module (ECM)

Volvo models this fault code applies to

This fault code has different meanings depending on model, model year or engine. Select the meaning that applies to your car.

Applies to the following models:

7 models

S60 (2011–), S80 (2007–), V40 (2013–), V40 Cross Country (2013–), V60 (2011–), V70 (2008–), XC60 (2009–)

Show models by year and engine (20)

What does this fault code mean?

Possible causes

Damaged rear oxygen sensor

What you can do

1Read the code, clear it and road test the car to see whether it comes back
2Check the connector to the rear sensor for contact resistance and oxidation; do not use rust solvent spray or grease
3Use a multimeter to check that the wires to the sensor have no open circuit and are not shorted to each other
4If the connector and wires are intact, replace the rear oxygen sensor

Symptoms you may notice1

Check engine light (MIL) on

What the fault can affect1

Control with the rear oxygen sensor is switched off

General guidance for car owners. Diagnosis on the car can point to a different cause.

ECM-P014100 - O2 Sensor Heater Circuit (Bank 1 Sensor 2). General Failure Information. No sub type information

Volvo models this fault code applies to

O2 Sensor Heater Circuit (Bank 1 Sensor 2). General Failure Information. No sub type information

O2 Heater Circuit (Bank 1, Sensor 2). General Failure Information. No sub type information

Applies to the following models:

What does this fault code mean?

Possible causes

What you can do

Symptoms you may notice1

What the fault can affect1

ECM-P014100 - O2 Sensor Heater Circuit (Bank 1 Sensor 2). General Failure Information. No sub type information

Volvo models this fault code applies to

O2 Sensor Heater Circuit (Bank 1 Sensor 2). General Failure Information. No sub type information

O2 Heater Circuit (Bank 1, Sensor 2). General Failure Information. No sub type information

Applies to the following models:

What does this fault code mean?

Possible causes

What you can do

Symptoms you may notice1

What the fault can affect1