VOLVO
ECM-P020068 - Injector Circuit. Algorithm Based Failures. Event information
System
Engine Control Module (ECM)
Volvo models this fault code applies to
Applies to the following models:
5 modelsS80 (2007–), V70 (2008–), XC60 (2009–), XC70 (2008–), XC90 (2003–)
Show models by year and engine (6)
- Volvo S80 (2007–)2007–2009Engine D5244T4, D5244T5 only
- Volvo V70 (2008–)2008–2009Engine D5244T4, D5244T5 only
- Volvo XC60 (2009–)2009All engines except: B6304T2
- Volvo XC70 (2008–)2008All engines except: B6324S
- Volvo XC70 (2008–)2009Engine D5244T4, D5244T5 only
- Volvo XC90 (2003–)2013–2014Engine D5244T18, D5244T5 only
What does this fault code mean?
This code is an event-controlled information code and does not indicate a fault in the control module. It is set when one or more injectors are switched off, which can be done during fault finding. The code does not need to be cleared; it disappears by itself when the conditions no longer apply.
Possible causes
- One or more injectors are switched off, for example during fault finding with vehicle communication
What you can do
- 1There is no real fault finding procedure for this code, as it is an information code
- 2If you have switched off an injector with a diagnostic tool, switch it on again and check that the code disappears
Symptoms you may notice1
- No noticeable symptoms for the driver
General guidance for car owners. Diagnosis on the car can point to a different cause.