VOLVO
ECM-P024511 - Turbo/Super Charger Wastegate Solenoid A Low. General Electrical Failures. Circuit short to ground
System
Engine Control Module (ECM)
Volvo models this fault code applies to
Applies to the following models:
7 modelsS60 (2011–), S80 (2007–), V40 (2013–), V40 Cross Country (2013–), V60 (2011–), V70 (2008–), XC60 (2009–)
Show models by year and engine (20)
- Volvo S60 (2011–)2011Engine B4164T, B4164T3, B4204T6, B4204T7 only
- Volvo S60 (2011–)2012–2014Engine B4164T, B4164T2, B4164T3, B4204T7 only
- Volvo S60 (2011–)2015Engine B4164T, B4164T2, B4164T3 only
- Volvo S80 (2007–)2010Engine B4204T6 only
- Volvo S80 (2007–)2011Engine B4164T, B4204T6, B4204T7 only
- Volvo S80 (2007–)2012–2014Engine B4164T, B4164T2, B4204T6, B4204T7 only
- Volvo S80 (2007–)2015Engine B4164T only
- Volvo V40 (2013–)2013Engine B4164T, B4164T3 only
- Volvo V40 (2013–)2014–2015Engine B4164T, B4164T3, B4164T4 only
- Volvo V40 Cross Country (2013–)2013–2015Engine B4164T only
- Volvo V60 (2011–)2011Engine B4164T, B4164T3, B4204T6, B4204T7 only
- Volvo V60 (2011–)2012–2014Engine B4164T, B4164T2, B4164T3, B4204T7 only
- Volvo V60 (2011–)2015Engine B4164T, B4164T2, B4164T3 only
- Volvo V70 (2008–)2010Engine B4204T6 only
- Volvo V70 (2008–)2011Engine B4164T, B4204T6, B4204T7 only
- Volvo V70 (2008–)2012–2014Engine B4164T, B4164T2, B4204T7 only
- Volvo V70 (2008–)2015Engine B4164T, B4164T2 only
- Volvo XC60 (2009–)2010Engine B4204T6 only
- Volvo XC60 (2009–)2011–2012Engine B4204T6, B4204T7 only
- Volvo XC60 (2009–)2013–2015Engine B4204T7 only
What does this fault code mean?
The signal wire to the turbo control valve has been shorted to ground, so the engine control module (ECM) registers too low a voltage on it. The fault is therefore an electrical one where the wire is shorted to ground.
Possible causes
- Signal wire shorted to ground
- Damaged turbo control valve
What you can do
- 1Read the code, clear it and road test to see whether it returns
- 2With a diagnostic tool, activate the turbo control valve. A clear click from the engine bay shows that it works
- 3Look at the turbo control valve connector for contact resistance and oxidation
- 4Use a multimeter to check that the signal wire between the engine control module and the turbo control valve is not shorted to ground
- 5Check that the fuses are intact. Fuse locations are shown in the owner's manual
- 6If the fault remains, have a workshop check the turbo control valve with diagnostic equipment
Symptoms you may notice2
- The check engine lamp comes on or behaves abnormally
- The car feels poor to drive, with reduced performance and lack of power
General guidance for car owners. Diagnosis on the car can point to a different cause.