What does fault code ECM-P025A00 mean?

Diagnostic fault code details for ECM-P025A00 (Volvo S60 (2011–), Volvo S80 (2007–), Volvo V40 (2013–)). Repair service at OBD Tuning.

VOLVO

ECM-P025A00 - Fuel Pump A Control Circuit / Open. General Failure Information. No sub type information

System

Engine Control Module (ECM)

Volvo models this fault code applies to

Applies to the following models:

8 models

S60 (2011–), S80 (2007–), V40 (2013–), V40 Cross Country (2013–), V60 (2011–), V70 (2008–), XC60 (2009–), XC70 (2008–)

Show models by year and engine (8)

What does this fault code mean?

The ECM watches the control signal on its way to the PEM, the fuel pump control module. The code is stored when that signal is incorrect. The cause may be an open or short circuit in the wiring, or a fault in the fuel pump in the tank that gives too low pressure. The code is general and does not say what type of fault it is.

Possible causes

Open or short circuit in the wiring
Fault in the fuel pump in the tank, giving too low pressure

What you can do

1Read and note the fault code, clear it and test drive to see whether it returns
2Check that the fuses are intact
3Check the connector to the fuel pump control module for contact resistance and oxidation
4With the ignition off, use a multimeter to check that the control wire to the pump control module has no open or short circuit
5Have a workshop with diagnostic equipment check the fuel pump in the tank and its control module

Symptoms you may notice5

The engine does not start but cranks
The engine is hard to start and cranks slowly
The car hesitates or surges during acceleration
The engine stalls, at idle or while driving, at any time or all the time
A message in the display together with a warning symbol

General guidance for car owners. Diagnosis on the car can point to a different cause.