VOLVO
ECM-P034068 - Camshaft Position Sensor A Circuit (Bank 1 or single sensor). Algorithm Based Failures. Event information
System
Engine Control Module (ECM)
Volvo models this fault code applies to
Applies to the following models:
5 modelsS60 (2011–), S80 (2007–), V60 (2011–), V70 (2008–), XC60 (2009–)
Show models by year and engine (12)
- Volvo S60 (2011–)2011Engine B4204T6, B4204T7 only
- Volvo S60 (2011–)2012–2014Engine B4204T7 only
- Volvo S80 (2007–)2010Engine B4204T6 only
- Volvo S80 (2007–)2011–2014Engine B4204T6, B4204T7 only
- Volvo V60 (2011–)2011Engine B4204T6, B4204T7 only
- Volvo V60 (2011–)2012–2014Engine B4204T7 only
- Volvo V70 (2008–)2010Engine B4204T6 only
- Volvo V70 (2008–)2011Engine B4204T6, B4204T7 only
- Volvo V70 (2008–)2012–2014Engine B4204T7 only
- Volvo XC60 (2009–)2010Engine B4204T6 only
- Volvo XC60 (2009–)2011–2012Engine B4204T6, B4204T7 only
- Volvo XC60 (2009–)2013–2015Engine B4204T7 only
What does this fault code mean?
This is an event controlled code, meaning it shows an event and is intended as information. It does not point to a fault in the control module where it is active. The engine control module sets the code when it interprets the camshaft sensor signal as faulty, and the code disappears when the conditions no longer apply.
Possible causes
- Another fault that this code is a follow-on to
What you can do
- 1Read all the fault codes in the engine control module and see which ones relate to the camshaft sensor. Those are the ones to address first.
- 2Fix the root fault according to the code that was set first, then read the fault codes again with a diagnostic tool.
- 3This code is a consequence of other codes and does not need to be erased separately. It disappears when the conditions no longer apply.
Symptoms you may notice1
- No noticeable symptoms for the driver
General guidance for car owners. Diagnosis on the car can point to a different cause.