VOLVO
ECM-P060764 - Control Module Performance. Algorithm Based Failures. Signal plausibility failure
System
Engine Control Module (ECM)
Volvo models this fault code applies to
Applies to the following models:
5 modelsS80 (2007–), V70 (2008–), XC60 (2009–), XC70 (2008–), XC90 (2003–)
Show models by year and engine (8)
- Volvo S80 (2007–)2007–2009Engine D5244T4, D5244T5 only
- Volvo S80 (2007–)2010–2011Engine D4164T only
- Volvo V70 (2008–)2008–2009Engine D5244T4, D5244T5 only
- Volvo V70 (2008–)2010–2011Engine D4164T only
- Volvo XC60 (2009–)2009All engines except: B6304T2
- Volvo XC70 (2008–)2008All engines except: B6324S
- Volvo XC70 (2008–)2009Engine D5244T4, D5244T5 only
- Volvo XC90 (2003–)2013–2014Engine D5244T18, D5244T5 only
What does this fault code mean?
The ECM receives information from the brake control module (BCM) over the CAN network. The BCM can request reduced engine torque for a function in the system, and the code is set when such a request arrives at too low an engine speed. The code can only be detected while the stability system is active.
Possible causes
- Fault on the CAN network
- Fault in the brake control module (BCM), where the cause should be looked for
What you can do
- 1Read the code, clear it and road test the car with the stability system active to see whether it comes back
- 2Check the battery charge and that the battery terminals and earth connections are tight and clean
- 3Check that the connectors at the brake control module are tight and free from corrosion
- 4The brake control module (BCM) is part of the braking system, so have a workshop check it and the CAN network if the fault comes back
Symptoms you may notice1
- No noticeable symptoms for the driver
General guidance for car owners. Diagnosis on the car can point to a different cause.