VOLVO
ECM-P062D04 - Fuel Injector Driver Circuit Performance Bank 1. General Failure Information. System Internal Failures
System
Engine Control Module (ECM)
Volvo models this fault code applies to
Applies to the following models:
9 modelsS60 (2011–), S80 (2007–), V40 (2013–), V40 Cross Country (2013–), V60 (2011–), V70 (2008–), XC60 (2009–), XC70 (2008–), XC90 (2003–)
Show models by year and engine (16)
- Volvo S60 (2011–)2014–2015Engine B4204T10, B4204T11, B4204T12, B4204T15, B4204T9 only
- Volvo S80 (2007–)2007–2009Engine D5244T4, D5244T5 only
- Volvo S80 (2007–)2010–2011Engine D4164T only
- Volvo S80 (2007–)2014–2015Engine B4204T11, B4204T12, B4204T15 only
- Volvo V40 (2013–)2015Engine B4204T11 only
- Volvo V40 Cross Country (2013–)2015Engine B4204T11 only
- Volvo V60 (2011–)2014–2015Engine B4204T11, B4204T12, B4204T15, B4204T9 only
- Volvo V70 (2008–)2008–2009Engine D5244T4, D5244T5 only
- Volvo V70 (2008–)2010–2011Engine D4164T only
- Volvo V70 (2008–)2014–2015Engine B4204T11 only
- Volvo XC60 (2009–)2009All engines except: B6304T2
- Volvo XC60 (2009–)2014–2015Engine B4204T10, B4204T11, B4204T12, B4204T15, B4204T9 only
- Volvo XC70 (2008–)2008All engines except: B6324S
- Volvo XC70 (2008–)2009Engine D5244T4, D5244T5 only
- Volvo XC70 (2008–)2014–2015Engine B4204T11 only
- Volvo XC90 (2003–)2013–2014Engine D5244T18, D5244T5 only
What does this fault code mean?
The engine control module has built-in control systems that detect internal faults. If the monitoring registers a temporary fault in the injectors' control system, the fault code is set, and with an active fault the fuel supply is shut off. The fault can cause the engine not to start or to lack power.
Possible causes
- Signal interference
- System voltage too low
- Damaged injection valves
- Software error
- Communication problems
- Internal fault in the control module
What you can do
- 1With the ignition on, read the diagnostic status and fault status for the code
- 2Check that the fuses are intact
- 3After the test, see whether the fault is still present
- 4Have a workshop check that the control module's software is up to date
- 5If the fault remains: have a workshop check the injection valves and the control module with diagnostic equipment
Symptoms you may notice4
- The engine does not start, sometimes or all the time
- The engine lacks power
- The engine stalls on starting
- The check engine lamp lights or behaves abnormally
What the fault can affect1
- Fuel supply is shut off while the fault is active
General guidance for car owners. Diagnosis on the car can point to a different cause.